Advantech ECU-P1761 Installation and operation manual

STARTUP MANUAL
1 Startup Manual
ECU-P1761
4-ch Isolated Digital Input, 4-ch Isolated Relay Output with IRIG-B Board
Packing List
Before installation, make sure that you have the ECU-P1761
suit which includes the card and panel as below.
Diagram
The ECU-P1761 supports the following specifications:
• Connector: 120-pin connector for UNO-4673A/4683/ECU-
4784
• BUS Interface: PCI
• Dimensions: 5.3’’ x 6.0’’ (136 x 150 mm)
• Power Requirements: 5V @ 150mA (typical); 3.3V @
60mA (typical)
• Certification: CE, FCC, IEC-61850-3 Compliant
Digital Input
• Channels： 4
• Connector： Terminal Block
• Input Type： Wet Contact (Sink)
• Input Voltage： Logic 0: 0~10V; Logic
1: 30~48V
• Response time： 1 ms
• Isolation Voltage： 2,500 VDC
Relay Output
• Channels 4
• Connector Terminal Block
• Output Type Relay; 1 Form C
• Relay Output Voltage 250 VAC/VDC
• Max. Switching Voltage 400 VAC
• Relay Output Current: 25°C 3A,70°C, 1A
• Operate/Release Time： Max. 8ms
• Isolation Voltage： 2,500 VDC
IRIG-B
• IRIG Interface BNC
• Precision 1ms
• Resolution of time 1s
• Message Syntax YYYYQQQHHMMSS
(year, day, hour,
minute& second)
Installation
The ECU-P1761 is an expansion card for ECU-4784 which
has 2 expansion slots and UNO-4673A/4683 which has 3
expansion slots. ECU-P1761 can be plugged into any of the
slots. Follow these steps to integrate into ECU-4784/UNO-
4673A/4683.
1. Select one of the slots: unscrew the two screws on the
blank panel of the slot then remove the blanking plate.
2. Plug the ECU-P1761 into the selected slot of ECU-4784/
UNO-4673A/4683 carefully and fix it by the two screws
on the panel.
Notes
For more information on this and other Advantech products, please
visit our websites at:
http://www.advantech.com
http://www.advantech.com/eAutomation
For technical support and service:
http://www.advantech.com.tw/eservice
This manual is for ECU-P1761
Part No: 2003P17600 1st Edition
June 2016
If anything is missing or damaged, contact your distributor or
sales representative immediately.
Specications

STARTUP MANUAL
Startup Manual 2
4-ch Isolated Digital Input, 4-ch Isolated Relay Output with IRIG-B Board
Pin Assignment
Pin Description Pin Description
1 DI0 2 DI1
3 DI2 4 DI3
5 NC 6 NC
7 NC 8 NC
9 IGND 10 IGND
11 NC 12 NC
13 NC 14 NC
15 NC 16 NC
17 NC 18 NC
19 NC 20 NC
21 NC 22 NC
23 NC 24 NC
25 NC 26 NC
27 NC 28 NC
29 NO0 30 NO1
31 COM0 32 COM1
33 NC0 34 NC1
35 NO2 36 NO3
37 COM2 38 COM3
39 NC2 40 NC3