Advantech PCA-6004 Installation and operation manual

PCA-6004 Startup Manual 1
PCA-6004 Full-sized SBC with VIA C3 CPU, VGA and Ethernet
PCA-6004 Full-sized SBC with VIA C3 CPU,
VGA and Ethernet
Startup Manual
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
For technical support and service, please visit our
support website at:
http://support.advantech.com
This manual is for the PCA-6003 series Rev. A1
Part No. 2002600410 1st. Edition
Printed in Taiwan March 2002
Packing List
Before you begin installing your card, please make sure
that the following materials have been shipped:
• 1 PCA-6004 single board computer
• 1 FDD cable p/n: 1701340703
• 2 UDMA 66/100 HDD cables p/n: 1701400452
• 1 printer (parallel port) and COM port cable kit
p/n: 1701260305
• 1 ivory cable for PS/2 keyboard and PS/2 mouse
p/n: 1700060202
• 1 USB cable (optional) p/n: 1700100170
• This startup manual
• 1 driver CD-ROM with user's manual (in PDF format)
• Warranty certificate
If any of these items are missing or damaged, contact
your distributor or sales representative immediately.
Note 1: For detailed contents of this product, please
refer to the enclosed CD-ROM or disk (in
PDF format).
Note 2: Acrobat Reader is acquired to view any PDF
file. Acrobat Reader can be downloaded at:
www.adobe.com/Prodindex/acrobat/
readstep.html
(Acrobat is a trademark of Adobe.)
Specifications
Standard SBC Functions
•CPU:VIA C3 800 MHz low power CPU with 128 KB L1
and 64 KB L2 cache
•BIOS: Award 2 Mb Flash memory BIOS
•System memory: Two 168-pin DIMM sockets
accepts up to 1 GB SDRAM
•Enhanced IDE interface: Supports up to four EIDE
devices. BIOS auto-detect, PIO Mode 3 or Mode 4,
UDMA 33/66/100 transfer
•FDD interface: Supports up to two FDDs
•Serial ports: Two serial RS-232 ports,
•Parallel port: One parallel port, supports
SPP/EPP/ECP mode
•Keyboard/mouse connector: Supports a standard
PS/2 keyboard and a PS/2 mouse
•Power management: Supports power saving modes
including Normal/Standby/Suspend modes.
•Watchdog timer: 63 level timer intervals
• USB: Two Universal Serial Bus ports
VGA/LCD Interface
•Controller: Chipset integrated high performance
VGA controller
•Display memory: Share system SDRAM up to 8 MB
Ethernet Interface
• Chipset: Realtek™ RTL8139 C
• Ethernet interface: PCI 10/100 Mbps Ethernet, IEEE
802.3U protocol compatible
• Connection: On-board RJ-45 connector

2PCA-6004 Startup Manual
The board has a number of jumpers that allow you to
configure your system to suit your application.
The table below lists the function of each of the
jumpers and connectors.
Label Function
J1 CMOS clear
J2 Watchdog timer output
Label Function
CN1 Primary IDE connector
CN2 Secodary IDE connector
CN3 Floppy drive connector
CN4 Parallel port
CN6 USB port
CN7 VGA connector
CN8 10/100 LAN connector
CN9 Serial port: COM1
CN10 Serial port: COM2
CN11 PS/2 keyboard and mouse
CN12 External keyboard connector
CN13 Infrared (IR) connector
CN14 CPU FAN connector
CN16 POWER LED
CN17 External speaker
CN18 Reset connector
CN19 HDD LED connector
CN20 ATX feature connector
CN21 ATX soft power switch
CN29 External SM bus connector
CN41 LCD flat panel connector
CN42 LCD flat panel inverter power connector
CN43 AC-97 Audio Interface
Jumpers and Connectors
Specifications Cont.
Mechanical and Environmental
•Dimensions (L x W): 338 x 122 mm
•Power supply voltage: +5 V, ± 12 V
•Power requirements: 3.14 A @ +5 V, 110mA @ +
12 V (typical, with 128 MB SDRAM)
•Operating temperature: 0 ~ 60° C
•Weight: 0.5 kg (weight of board)
J1: CMOS clear function
Closed pins Result
1-2 Keep CMOS data*
2-3 Clear CMOS
321
J2: Watchdog timer output
Closed pins Result
1-2 IRQ11
2-3 System reset *
* denotes default setting

PCA-6004 Startup Manual 3
PCA-6004 Locating connectors
CN 19 CN 17 CN 16
CN 9
CN 8
CN 7
CN 11
CN18
CN21
CN29
CN1 CN2 DIMM1
DIMM2
CN 3 CN 4 CN 10
CN20
CN 6
CN 12
CN 14
J1
J2
CN43
CN 13
CN 41
CN 42