AFi SS101 User manual

www.afibranding.com.au | 1300 652 514 | 33 Lakewood Blvd, Carrum Downs, Vic, 3201
Corner Brackets
ReFrame® Lengths
Allen Key
4x
4x
1x
1
CHECKLIST
1
SS101 - single-sided ReFrame®
assembly instructions
Lay out the ReFrame®
components on a flat
surface and ensure you have
everything required before
you start the assembly.
Insert corner brackets into the channels of the top and bottom lengths of frame (screws may need to be loosened to
allow brackets to slide into position)
NOTE: To ensure a precise line-up of the frame profiles, do not tighten any of the screws until you have reached step 6
2
Slide top and side length together Repeat on the opposite corner so that 3 lengths are
connected
3 4
scan for
assembly video

Attach the remaining two corners at the same time
Repeat step 7 on all remaining corners
Ensure corner is aligned and then tighten screws using
allen key
5
7
6
SS101 - single-sided ReFrame®
assembly instructions
www.afibranding.com.au | 1300 652 514 | 33 Lakewood Blvd, Carrum Downs, Vic, 3201
Applying your custom ReFrame® fabric skin
8
Developed by AFI Branding
Now that you’ve finished assembling your ReFrame®, it’s time to apply your custom ReFrame® fabric skin. Please refer to
either a printed ‘ReFrame® Fabric Installation Guide’ or go to www.reframe.com.au to watch one of our instructional
assembly videos to see how to correctly apply your ReFrame® fabric skin.
NOTE: The assembly instructions for the SS101 (and included components) illustrate the fundamental steps to assemble a
‘standard’ Single-Sided type ReFrame®. If your Reframe® is oversize, has additional components such as joiners (not shown on
this fact sheet), accessories, or has bends/curves and you are unsure how to proceed with assembly, please contact the team
at AFI Branding on 1300 652 514 and we will guide you through the assembly process.