Albixon Nozzle User manual

Recirculation
Nozzle
VERZE 31. 8. 2017 / REVIZE: 31. 8. 2017
EN
INSTALLATION
AND USER GUIDE

2/ Recirculation Nozzle
Installing nozzles on the pool wall
Instructions for use
•One of the most important factors in the design phase of the pool is planning an efficient and reular
recirculation of the water in the pool.
•The specific function of the return nozzle is to create a flow in the pool with the help of the return
water from the filtration system.
•The required number of inputs is determined by the type of pool and the required flow. The location
of inputs is also important to produce a uniform circulation of water without the formation of dead
spots.
•For pools with skimmers (placed against the prevailing wind direction, pics. 1 and 2) the return inlets
should be placed either opposite or on the sides of the wall.
•For pools where an overflow channel is installed, it Is recommended that you install the return inputs
at the bottom of the pool, or at the bottom of the side walls (pic. 3).
1.
the deeper end
of the pool
skimmer
nozzle
PIC. 1
PIC. 3
200-300 mm
PIC. 2
200-300 mm

Recirculation Nozzle / 3
Warranty conditions
The warranty conditions are governed by the commercial and warranty conditions of your supplier.
Safe liquidation of the product at the end of its useful life
Once the product’s useful life has ended, please ensure its ecological liquidation by a specialised
company.
Complaints and Service
Claims are governed by the relevant acts on consumer protection.
In the event of any irreparable defects, please contact your supplier in writing.
Date ................................................................
Supplier

Thank you
for using ALBIXON
products
ALBIXON
[e-mail]
www.ALBIXON.com
Note that the photos used in the manual are illustrative only. Printing and typesetting errors reserved.