Alinco DR-1200T User manual

-THE DR-1200T PROVIDES 25W RF OUT-
‘UT WITH HI/LOW POWER SELECTION
SWITCH.
140(W) x 40(H) x 170( D)mm (5-l/2” x 2” x
6-3/4”) AT 2.25 Ibs.
THE UNIT CONTAINS 14 FULLY PRO-
GRAMMABLE MEMORY CHANNELS.
EACH CHANNEL STORES OPERATING
FREQUENCY, STANDARD OFFSET,
AND OTHER USEFUL INFORMATION.
ILLUMINATED LCD DISPLAY WITH
FUNCTION INDICATORS.
FOR EASE OF OPERATION 5, 10, 12.5,
15, 20, AND 25 kHZ STEPS.
(a) VFO SCANNING OF THE ENTIRE
BAND.
(b) MEMORY SCANNING OF THE EN-
TIRE BAND.
(c) PROGRAMED BAND-SCANNING OF
A SELECTED SEGMENT OF THE
BAND.
(d) PRIORITY SCANNING ALLOWS SE-
LECTION OF A FREQUENCY, IN
VFO OR MEMORY TO SERVE AS
A PRIORITY FREQUENCY.
CODE/DECODE SUBAUDIBLE TONES.
l REVERSE KEY-INVERTS TX-RX
0MEMORY SKIP
0 ODD OFFSET
l MULTIPLE STANDARD OFFSETS
. .
OTHERS TOO NUMEROUS TO
LIST.
. AS STANDARD.
. INTERFACE CABLE
.DC POWER CABLE
. RUBBER FOOT

0 General
INTERFACE CABLE
Frequency Coverage ~~~~~~~~~~~~~~~~~~~~144.00-147.995MHz(U.S. Version)
Frequency Resolution..............
........5, 10, 12.5, 15, 20 and 25kHz
Antenna Impedance
. . . . . . . . . . . . . . . . . . . . . . . 60 ohms unbalanced
Power Supply requirement
.* . . . . . . . . . . . . . . 3.8 Volts D,C,
Current Drain at 13,8V...................‘.Receiving
Squelched: Does not exeed 500mA
Transmitting
High: 25W approx 5.5A
Low : 5W approx 2.5A
Dimension . . . . . . . . . . . . . . . . . . . . . . . . . .
14Omm(W) x 40mm(H) x 170mm(D)
(5-l/2”) x (2”) x (6-3/4”)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..I..... 2,25LBS
0 Transmitter
Output power... . . . . . . . . . . . . . . . . . . . . . .High: ‘&LjW&s
Low: 5Watts
Emission Mode . . . . . . . . . . . . . . . . .FsE
Modulation System . . . . . . . . . . . . . . . ..‘..Variable Reactance F.M.
Max. Frequency Deviation...‘...........+SkHz
Spurious Emission .............
............More than 60dB below Carrier
Operating Mode ....
. . . . . . . . . . . . . . . . . . . . . . ..Simplex
Duplex: +-600 kHz l.GMHz, 5MHz, 7.6MHz
from receive frequency and 1 channel odd
offsets programmable
0 Receiver
Receiving System
. . . . . . . . . . . . . . . . . . ..Superhetrodyne. dual conversion
Modulation acceptance ..................F3E
Intermediate frequency ...............*...ist 10.7MHz 2nd 455kHz
Sensitivity
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2dB SINAD less than 0,16pV
Selectivity
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . More than +6KHzat -6dB
Audio Power Output....
...................More than 1.5Watts(8ohms -10% Distortion)
Speaker Impedance
. . . . . . . . . . . . . . . .8 ohms
Note:Specifications are subject to change without notice.
Specifications are guaranteed for amateur band only.
Gray:GROUND@
(AUDIO INPUT)
Red.PTT@
@Black:GROUND
@Orange.SPEAKER OUTPUT
Remarks:The number of cables are five and
Cj), 0, @are un-useful.
llFront Panel
n LCD Panel
@Main Dial
@LCD Panel
@Volume Control
@Squelch Control
@H/L Switch
OPower Switch
@Function/Memory Write Key
@MHz(Band) Key
@VFO/M/Channel Step Key
@Reverse/Lock Key
@Shift Key
@Sub Tone/Beep Key
@Priority Key
@Scan/Memory Skip Key
@Call Channel/Call Channel Write Key
@Interface Jack
@Reverse Indication
@Offset Indication
@Tone Encoder Indication
@Tone Decoder (Tone Squelch) Indication
@Priority Indication
@Call Channel Indication
@Frequency Indication
@Decimal Readout Point
@Busy Indication
@S/RF Meter Indication
@On Air Indication
@Memory Indication
@Memory Channel Indication
Authorized Dealer:
lo
k ALINCO
--Y
ELECTmmlCS IWC.
Head Office: “TWIN 21” MID Tower Building 23F. l-61.2~Chome, Shiromi,
Chuo-ku. Osaka No.540. Japan
Factory:
1-1-l. Mishimae, Takatsuki. Osaka No.569. Japan
1 ALINCO ELECTRONICS INC.
438 Amapola Avenue, Unit130, Torrance, CA 90501, U.S.A.