Allegion Falcon Security Strike User manual

Security Strike Installation
A: Mark the corners of
the deadbolt with crayon
or grease pencil. Retract
deadbolt and close door.
Throw deadbolt firmly
against jamb to transfer
markings.
B: Bore 1” diameter hole
1¹⁄₈” deep, centered
between the markings.
Caution: Deadbolt will
not function correctly if
hole is too shallow.
C: Place strike on jamb,
centering over hole and
parallel to edge of frame.
Mark outline and remove
strike.
E: Install strike with screws
provided. Put 3” long screws
closest to door stop. Predrill
¹⁄₈” diameter holes. Lubrication
of screws recommended.
D: Chisel cutout ³⁄₃₂” deep.
© Allegion 2014
Printed in U.S.A.
030289-000-70 Rev. 10/14-d

Additional Notes: Revision History Revision Description:
D > Revised artwork
1. None A B C D E F
5305 0790 6683
Material
White Paper
Edited By Approved By EC Number Release Date
J. Ellis M. Roberts xxxxx 10/14
Notes
1. printed one side
2. printed black
3. tolerance ± .13
4. printed in country may vary
Title
Security Strike Installation
Creation Date
10-29-14
Number
030289-000-70
Revision
D
Created By
J. Ellis Activity
3899 Hancock Expwy
Security, CO 80911 © Allegion 2014Software: InDesign CS6
5.13
3 .75
FRONT
BEGINNING SHEET