Allied Telesis AT-TQ6602 GEN2 User manual

613-003194 Rev. A
TQ6602 GEN2
WIRELESS ACCESS POINTS
AT-TQ6602 GEN2
AT-TQm6602 GEN2
802.11ax Dual-radio 5G/2.4GHz 4x4+4x4 Wireless AP
Installation Guide

Copyright  2023 Allied Telesis, Inc.
All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesis, Inc.
Allied Telesis and the Allied Telesis logo are trademarks of Allied Telesis, Incorporated. All other product names, company names,
logos or other designations mentioned herein are trademarks or registered trademarks of their respective owners.
Allied Telesis, Inc. reserves the right to make changes in specifications and other information contained in this document without prior
written notice. The information provided herein is subject to change without notice. In no event shall Allied Telesis, Inc. be liable for
any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related
to this manual or the information contained herein, even if Allied Telesis, Inc. has been advised of, known, or should have known, the
possibility of such damages.

TQ6602 GEN2 Access Points Installation Guide
3
Electrical Safety and Emissions
Standards
This product meets the following standards:
“Safety and Electromagnetic Emissions” on page 4
“Translated Safety Statements” on page 7

4
Safety and Electromagnetic Emissions
Standard Compliance
RoHs compliant
European Union RoHS (Directive 2011/65/EU of the European Parliament and of the Council
of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and
electronic equipment.)
Wire Communication
IEEE 802.1
IEEE 802.3
IEEE 802.3u
IEEE 802.3z
IEEE 802.3ab
IEEE 802.3bz
IEEE 802.3x
IEEE 802.3at
ITU-T G.993.1
Wireless Communication
IEEE 802.11 DSSS
IEEE 802.11a OFDM
IEEE 802.11b DSSS/FHSS
IEEE 802.11g OFDM
IEEE 802.11n OFDM
IEEE 802.11ac OFDM
IEEE 802.11ax OFDMA
Safety
CB/UL
• IEC 62368-1
• UL 62368-1
• CSA C22.2 No. 62368-1
• IEC 60950-1
TUV
• EN62368-1 (Co-license)
UL2043

TQ6602 GEN2 Access Points Installation Guide
5
Electro Magnetic Interference (EMI)
FCC part15 Subpart B/ Class B
EN55032 Class B
VCCI-CISPR 32 / Class B
AS/NZS CISPR 32
Electro Magnetic Susceptibility - EN55024 and EN55035
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-4
IEC 61000-4-5
IEC 61000-4-6
IEC 61000-4-8
IEC 61000-4-11
IEC 61000-3-2
IEC 61000-3-3
FCC
47 CFR Part15, subpart C
47 CFR Part15, subpart E
DFS
CE
RED Directive 2014/53/EU
EN55032
EN55024
EN301489-1 V2.1.1
EN301489-17 V3.1.1
EN300328 V2.2.2
EN301893 V2.1.1
EN62311/ EN50385
European Council Directive 2014/30/EU
DFS
EN550.5
EN60601-1-2

6
RCM
AS/NZS CISPR 32
AS/NZS 4268
IC
ICES-003
RSS-102
RSS-247
Japan
JATE
ARIB STD-T66
ARIB STD-T71
Hong Kong OFCA
India WPC
Malaysia SIRIM
Singapore IMDA TS SRD
Figure 1. Singapore IMDA Logo
Taiwan BSMI & NCC
CNS 13438
CNS 14336-1
(LP002)
Thailand NBTC
Vietnam MIC
China SRRC
Complies with
IMDA Standards
DB102434

TQ6602 GEN2 Access Points Installation Guide
7
Translated Safety Statements
Important: The  indicates that a translation of the safety statement is available in a PDF document
titled Translated Safety Statements on the Allied Telesis website at www.alliedtelesis.com/library.
Remarque: Les consignes de sécurité portant le symbole  sont traduites dans plusieurs langues
dans le document Translated Safety Statements, disponible à l'adresse www.alliedtelesis.com/
library.

8

9
Contents
Preface ............................................................................................................................................................15
Safety Symbols Used in this Document .................................................................................................... 16
Contacting Allied Telesis ........................................................................................................................... 17
Chapter 1: Product Description ...................................................................................................................19
Hardware Components .............................................................................................................................. 20
Cable Hide........................................................................................................................................... 22
Console Port........................................................................................................................................ 22
Power Switch....................................................................................................................................... 22
Kensington Lock Hole.......................................................................................................................... 22
Reset Button........................................................................................................................................ 22
LAN1 and LAN2 Ports................................................................................................................................ 23
Static Link Aggregation........................................................................................................................ 23
Cascade Mode .................................................................................................................................... 24
Power Over Ethernet Plus (PoE+)....................................................................................................... 25
Connector Type ................................................................................................................................... 25
Speed .................................................................................................................................................. 25
Duplex Mode ....................................................................................................................................... 25
Automatic MDIX Detection .................................................................................................................. 25
Cable Requirements............................................................................................................................ 26
Maximum Distance .............................................................................................................................. 26
Port Pinouts ......................................................................................................................................... 26
Guidelines............................................................................................................................................ 26
AC Adapter for External Power Supply...................................................................................................... 27
LEDs .......................................................................................................................................................... 28
Chapter 2: Installing the Wireless Access Point ........................................................................................31
Reviewing Safety Precautions ................................................................................................................... 32
Unpacking the Shipping Box...................................................................................................................... 35
Reviewing Installation Guidelines .............................................................................................................. 36
Installing the Access Point on a Table ....................................................................................................... 38
Overview to Installing the Access Point on a Wall or Ceiling..................................................................... 39
Pre-fitting the Mounting Bracket on the Access Point................................................................................ 40
Installing the Mounting Bracket on a Wall or Ceiling.................................................................................. 42
Connecting Ethernet Cables to LAN1 and LAN2 Ports.............................................................................. 46
Guidelines............................................................................................................................................ 46
Connecting the Ethernet Cables to LAN Ports .................................................................................... 46
Connecting the AC Power Adapter ............................................................................................................ 48
Attaching the Access Point to the Mounting Bracket ................................................................................. 49
Installing an Anti-theft Device..................................................................................................................... 52
Starting the First Management Session..................................................................................................... 53
Appendix A: Technical Specifications ........................................................................................................55
Physical Specifications............................................................................................................................... 55
Environmental Specifications..................................................................................................................... 55
Power Specifications.................................................................................................................................. 56
External AC Adapter Specifications..................................................................................................... 56
PoE+ Power Requirements ................................................................................................................. 56

Contents
10
Cable Specifications ...................................................................................................................................57
LAN Ports Specifications and Pinouts ........................................................................................................58
Port Specifications ...............................................................................................................................58
Port Pinouts..........................................................................................................................................58
Appendix B: Regulatory Statements ........................................................................................................... 59
Federal Communication Commission Interference Statement ...................................................................60
European Union Restriction of the Use of Certain Hazardous Substances (RoHS) in Electrical and Electron-
ic Equipment .....................................................................................................................................................62
Industry Canada Statement........................................................................................................................63
Europe - EU Declaration of Conformity ......................................................................................................65
Operating Frequencies and Maximum Transmission Power Levels....................................................65
Radiation Exposure Statement ............................................................................................................65
Importer................................................................................................................................................65
UK - UKCA Declaration of Conformity........................................................................................................66
Operating Frequencies and Maximum Transmission Power Levels....................................................66
Radiation Exposure Statement ............................................................................................................66
Importer................................................................................................................................................66
Appendix C: Radiation Patterns .................................................................................................................. 67
TQ6602 GEN2 and TQm6602 GEN2 Access points..................................................................................68
Antenna Locations ...............................................................................................................................68
Axes on the Access Point ....................................................................................................................68
4x4 2.4G...............................................................................................................................................69
4x4 5G..................................................................................................................................................70

11
Figures
Figure 1: Singapore IMDA Logo ........................................................................................................................ 6
Figure 2: TQ6602 GEN2 and TQm6602 GEN2 Access Point Top View ......................................................... 20
Figure 3: Access Point Bottom View ............................................................................................................... 20
Figure 4: Front Edge View............................................................................................................................... 21
Figure 5: Back Edge View ............................................................................................................................... 21
Figure 6: Left Edge View ................................................................................................................................. 21
Figure 7: LAN1 and LAN2 Ports in a Static LAG ............................................................................................. 23
Figure 8: LAN2 Port in Cascade Mode with an End Node .............................................................................. 24
Figure 9: LAN2 Port in Cascade Mode with a Networking Device .................................................................. 24
Figure 10: PWRADP-01 (DA-48Z12) Power Adapter...................................................................................... 27
Figure 11: TQ6602 GEN2 and TQm6602 GEN2 Access Points’ LEDs........................................................... 28
Figure 12: Shipping Box Components............................................................................................................. 35
Figure 13: Approved Installation Orientations on a Ceiling, Wall, or Table ..................................................... 37
Figure 14: Attaching the Bracket Screws to the Access Point......................................................................... 40
Figure 15: Panel Screw ................................................................................................................................... 40
Figure 16: Attaching the Mounting Bracket on the Access Point..................................................................... 41
Figure 17: Removing the Mounting Bracket from the Access Point ................................................................ 41
Figure 18: Marking the Holes for the Key-Hole Slots ...................................................................................... 42
Figure 19: Installing Two Screws..................................................................................................................... 43
Figure 20: Installing the Mount Bracket On the Screws .................................................................................. 44
Figure 21: Pre-Drill Holes on Mounting Bracket .............................................................................................. 44
Figure 22: Securing the Mount Bracket ........................................................................................................... 45
Figure 23: Connecting an Ethernet Cable to the LAN1 Port............................................................................ 46
Figure 24: Connecting the Ethernet Cable to the LAN2 Port........................................................................... 47
Figure 25: Connecting an AC Power Adapter to the Access Point.................................................................. 48
Figure 26: Installing the Access Point on the Mounting Bracket ..................................................................... 49
Figure 27: Seating the Access Point on the Mounting Bracket ....................................................................... 50
Figure 28: Tightening the Mounting Bracket Thumbscrew .............................................................................. 50
Figure 29: Fitting the Cables in the Cable Hide............................................................................................... 51
Figure 30: Kensington Lock Port Location....................................................................................................... 52
Figure 31: Login Prompt .................................................................................................................................. 53
Figure 32: Pin Layout for RJ45 Connector on LAN Port.................................................................................. 58
Figure 33: Antenna Axes on the TQ6602 GEN2 and TQm6602 GEN2 Access Points................................... 68
Figure 34: Axes on the TQ6602 GEN2 and TQm6602 GEN2 Access Points ................................................. 68

List of Figures
12

13
Tables
Table 1. LED Status Information .................................................................................................................... 28
Table 2. Physical Specifications ..................................................................................................................... 55
Table 3. Environmental Specifications ........................................................................................................... 55
Table 4. External AC/DC Adapter Specifications ........................................................................................... 56
Table 5. PoE+ Power Specifications on LAN Ports ........................................................................................ 56
Table 6. LAN Port Specifications .................................................................................................................... 58
Table 7. Pin Signals for 100M/1G/2.5G/5G Base-T Connectors .................................................................... 58

List of Tables
14

15
Preface
This guide contains the hardware installation instructions for the TQ6602
GEN2 Access Points. The access point models included in this manual
are:
TQ6602 GEN2
TQm6602 GEN2
This preface contains the following sections:
“Safety Symbols Used in this Document” on page 16
“Contacting Allied Telesis” on page 17

Preface
16
Safety Symbols Used in this Document
This document uses the following conventions.
Note
Notes provide additional information.
Caution
Cautions inform you that performing or omitting a specific action
may result in equipment damage or loss of data.
Warning
Warnings inform you that performing or omitting a specific action
may result in bodily injury.
Warning
Warnings inform you of hot surfaces.

TQ6602 GEN2 Access Points Installation Guide
17
Contacting Allied Telesis
If you need assistance with this product, visit Allied Telesis web site at
www.alliedtelesis.com/support.

Preface
18

19
Chapter 1
Product Description
The sections in this chapter describe the hardware components of the
TQ6602 GEN2 Wireless Access Points:
“Hardware Components” on page 20
“LAN1 and LAN2 Ports” on page 23
“AC Adapter for External Power Supply” on page 27
“LEDs” on page 28

Chapter 1: Product Description
20
Hardware Components
The top view of the TQ6602 GEN2 or TQm6602 GEN2 Access Point is
illustrated in Figure 1.
Figure 1. TQ6602 GEN2 and TQm6602 GEN2 Access Point Top View
The bottom view is illustrated in Figure 2.
Figure 2. Access Point Bottom View
Front Edge
Back Edge
Cable
Hide
Front Edge
Back Edge