AMP Lighting AFL-40 B-BZ Series Operating and safety instructions

INSTALLATION & MAINTENANCE GUIDE
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com
AMP®Low Voltage Landscape Lighting
AMP® 12V LED Brass Flood Light with Yoke Mount (Constant Output)
AFL-40XX-B-BZ

AMP®12V LED Brass Flood Light with Yoke Mount (Constant Output)
AFL-40XX-B-BZ
INSTALLATION & MAINTENANCE GUIDE
www.amplighting.com
–2–
[email protected] • 813.978.3900
–3–
Important Safety Instructions: Read Before Installation
!
Important Safety Instructions
!
Package Contents
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situation.
1. Make sure that the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M)
or more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 12V AC.
4. Wiring connections must be made with wire connectors that are suitable
for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or
tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm).
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.
1. Turn o/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
A. (1) Fixture body
Product Dimensions
Parts Required
A. (1) Mounting Accessory
B. (1) Coupler
C. (1) Hex Nut
2.92”
4.45”
5.35”
6.65”
4.48”
5.81”
1.98”
4”
3.43”
1.1”
2.29”
2.41”
1.04”
2.28”
1.15”
4.5”
7.48”
7.12”
4.91”
3.55”
4.84” 6.3”
5.77”
5.94”
1.18”
1.18”
1.18”
0.47”
0.63”
0.55”
12V, 12W 12V, 17W & 22W
12V, 27W

INSTALLATION & MAINTENANCE GUIDE
–4–
www.amplighting.com
–4–
2
1
[email protected] • 813.978.3900
–5–
INSTALLATION & MAINTENANCE GUIDE
3
4
AMP®12V LED Brass Flood Light with Yoke Mount (Constant Output)
AFL-40XX-B-BZ
MP®12V LED Brass Flood Light with Yoke Mount (Constant Output)
AFL-40XX-B-BZ
Install Stake
Determine the desired location
for mounting the stake. Hammer
the stake into the ground until
ange of stake is ush to grade.
To avoid damage to the stake,
place a board on top of the stake
while hammering.
Note: If the ground is hard and
the stake is dicult to install,
make a crosscut in the ground
using a at shovel.
Board
Ground
Stake
Thread the coupler onto the
stake. Place the yoke mount
of the xture body over the
coupler and secure with the
hex nut. Hand tighten until
snug.
Ground
Fixture Body
Supply Wires
Hex Nut
Yoke Mount
Coupler
Soil
Stake
Wire Connections
Install Fixture Body to Stake
Strip both leads from the xture wires. Using two UL listed wire
connectors (sold separately), connect the leads from the xture wires
to the main supply cable leads.
Main Supply Cable
Fixture Wires
Wire Connectors
Adjust Fixture Body Direction
Adjust the xture body to the
desired orientation and tighten
the screws with the wrench.
After installation,
A. Check to make sure the xture is mounted properly.
B. Check to make sure the wires are connected properly.
Last, turn on the power and check if the lighting xture works. If not,
turn o the power and contact your local electrician.
Screw
Wrench
Rotate
Fixture Body

INSTALLATION & MAINTENANCE GUIDE
–6–
www.amplighting.com
–6–
[email protected] • 813.978.3900
–7–
AMP®12V LED Brass Flood Light with Yoke Mount (Constant Output)
AFL-40XX-B-BZ

IS-AFL-40XX-B-BZ-ver1.pdf
Specications and product details subject to change without notice.
© Copyright 2021, AMP®Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3900
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com