CONDUIT WALLBOX. REFER
= +/- .005
UNLESS OTHERWISE SPECIFIED:
TOLERANCE ON DECIMAL DIMENSIONS: XX = .010
= +.008 -.005
= +.006 -.005
FRACTIONAL DIMENSIONS INCLUDING HOLES: +/- 1/64
SURFACE FLATNESS .003 TIR PER LINEAR INCH.
DO NOT SCALE THIS DRAWING.
CUTOUT
property of AMX Corporation.
All information contained herein
that is not generally known
NOTICE: This drawing is the
written permission.
to the extent the information
for manufacture or sale without
shall be confidential except
has been previously established.
This drawing may not be copied,
reproduced, or used as the basis
UNDER .250 ú
TOLERANCE ON HOLE DIAMETERS:
ANGLES: +/- 1.0°
ALL DIMENSIONS IN INCHES.
.250 TO .500
OVER .500
BEZEL OUTLINE
MOUNTING / MILLWORK SPECIFICATION
MIO MODERO DMS & PINNACLE
SP2408-01
SP2408-01
A
FULL
1 OF 2
REV APPR
DRAWN
ENGR SERV
ENGINEER
REL APPR REL DATE
XXX = .005
SIZE
D
PROD ENGR
QUALITY
MATL SUP
PROJECTION
THIRD ANGLE
REV.
SHEET
DWG. NO.SCALE:
TO THE MOUNTING SPECIFICATION SP2408-02
MOUNTING DIMENSIONS AND
FOR FOR SPECIFIC
INFORMATION.
DRYWALL EXPANSIONS CLIPS
IF UNIT IS INSTALLED USING
THIS NOTCH IS ONLY NEEDED
THESE 4 HOLES ARE ONLY REQUIRED
WHEN MOUNTING UNIT TO A SOLID
SECURE UNIT WITH #4 SCREWS.
SURFACE (PODIUM, DESK, ETC.).
(2 PROVIDED)
REVISIONS
THIS CUTOUT WILL NOT
ACCOMMODATE THE
NOTICE
A7591 RELEASE TO MANUFACTURING
REV ECN DATE APPROVEDDESCRIPTION
