&Tradition DEVELIUS EV1 User manual

DEVELIUS E V1 & E V2
BY
EDWARD VAN VLIET
2018
USER INSTRUCTIONS
Congratulations with your new Develius Sofa, designed in 2018 by
Edward Van Vliet. We hope you will enjoy using this product and follow
these instructions to ensure correct installation. If you have any questions
or comments, please do not hesitate to contact us by mail on:
[email protected]
CONTENTS
A - Modules
B - Brackets (2 pcs. supplied for each module)
C - Screws (4 pcs. supplied for each module)
Please read these instructions carefully and retain them for future reference to ensure
that the product is correctly installed should it be moved or sold. For your own safety,
please study each step of this instruction manual before you commence installation.
&tradition are not responsible for any faults or damages caused by not following these
instructions correctly. Do not modify this product in any way.
TOOLS NEEDED
- Phillips-head screwdriver
SAFETY PRECAUTIONS
- Dispose of any plastic bags and foam from packaging and do not allow children to
play with it.
- The sofa is only intended for interior use.
- Two people are needed to assemble this product. Do not assemble on your own.
CLEANING INSTRUCTIONS
- Vacuum the furniture regularly using the upholstery nozzle to remove dust and
avoid uff and pilling.
- Straighten the fabric with your hands from time to time. Wrinkles in the fabric can
be straightened using a steamer.
- Soak up spilled liquids immediately with an absorbent napkin or cloth by dabbing
gently towards the centre of the stain.
- Most stains can be removed with lukewarm water on a clean lint-free cloth.
If necessary, add a little neutral detergent. Avoid rubbing the material hard as
this could result in loss of colour and damage the fabric. It may also be necessary
to use a hairdryer to avoid leaving an outline.
- Never use concentrated detergents or bleach ammonia or soap intended for
hard surfaces.
A
BC
ANDTRADITION.COM

STEP 1
Tilt one of the modules carefully on to the back. When the sofa is standing on the back -
take notice of the pre-drilled holes in the wooden frame.
STEP 2
Place the linking brackets over the pre-drilled holes and fasten with the supplied screws
using a screwdriver.
STEP 3
When the brackets are rmly attached to the module - carefully lift the module back on
the feet again.
STEP 4
Two persons are needed for this step. Do not assemble the modules on your own.
Take the next module which is supposed to be attached to the rst module and lift it over
the brackets and carefully put the module down over the brackets from the other module.
Make sure that both modules are rmly standing on the ground.
Pre-drilled holes