Anker 7 Series User manual

--
ANKER
ANKER 733 POWER BANK
(GaNPrime PowerCore 65W )
•
QUICK START GUIDE

Using as a Portable Charger
1.Check the battery level.
2. Charge your devices.
I
/ '
~Ao · o·
V U . 0 • •
~
\Iv I / +
25% 50 % 75 °/o 100% D
[ J [ J
....
[ ' J c
10 h
// .
- ·IQ_;
•IQ
I I KH ' I I~ r;i
I,.. ,/ II 0 +
\ I

3.Charge accessories.
0
Active trickle -charging mode to
charge your earbuds.
•
0
( )
c[J:l========~
i( )
Q'

..--
><
>
.
-
..
@ @
uu
a::
w
~
z
<:
<»
"O
0
E
Cl
C
Cl
L. I'll
.c.
u
I
~
.::£
u
·c
-
.
-::
X
Q.I
~

ffi
::c
~
I
ro
cu
0::
c
=>
·- 0
-
L-
·-
Cl)
en~
-3 0
a..
a.

Specifications
~~0)1±~
Cell Capacity
10000mAh
tJ~~fd
AC Input/ ACA1J 1
00V-240V-50-60Hz / 1.63A
USB-C 1 Input
5V =3A / 9V =2A / 12V = 1.5A
USB-C 1 AJJ
Charger mode/ ;f~~t- ~
USB-C 1 Output 5V = 3A / 9V = 3A / 12V=1.5A /
US B -C 1 1.±11.J
15V= 3A / 20V = 3.25A (65W max)
USB-C 2 Output 5V =3A / 9V =3A / 1
5V =
USB-C 2 1.±ltJ
3A / 20V = 3.25A (65W max)
USB-A Output 5V = 3A / 9V = 2A / 1 av = 2.25A /
USB-A 1.±ltJ
12V= 1.5A (22.SW max )
Total Output 65W Max
.g-ttl±ltJ
Battery mode/ /\'YT
1) -
t- ~
USB-C 1/C 2 Output 5V = 3A / 9V = 3A / 12V =1.5A /
USB-C 1/C 2 1.±11.J
15V= 2A / 20V = 1.SA (30W max )
USB-A Output
5V=3A / 9V=2A / 10V=
USB-A 1.±ltJ
2.25A / 12V= 1.5A (22. SW max )
Total Output 5V =3A Max
.g-ttl±lt.J
,

For FAQs and more information, please visit:
anker.com/support
@anker_official
@ankerjp
0
@Anker Deutschland
@Anker Japan
@Anker
0
@AnkerOfficial
@Anker_JP
Product Number: A 1651 51005003417 V0l

•
• The plug may vary depending on the region .
• When your Power Bank is fully charged, the LED indicators will
turn off after 10 minutes.
• For the fastest and safest charge, use an Anker cable, your
device's original cable, or other certified cables (such as MFi)
• When your USB·C to Lightning cable is not in use, disconnect ii
from Power Bank to avoid extra power consumption.
• The Power Bank will charge your device first before recharging
itself.
Important Safety Instructions
When using this product, basic precautions should always be followed,
including the following:
1). Read all the instructions before using this product.
2). The product Is designed for use with IT equipment only.
3). When charging a device, this product may feel warm. This is a normal
operating condition and should not be a cause for concern.
4}.Operating temperature should be between 0°( to 35°(/ 32°F to 95°F .
5) The socket-outlet shall be installed near t he equipment and shall be easily
accessible.
6).Use of a power supply or charger not recommended or sold by the product
manufacturer may_result in a risk of fire or personal injury
7) Do not use this product if it is damaged or modified. Damaged or modified
batteries may exhibit unpredictable behavior resulting in fire, explosion, or
risk of injury.
8). To reduce the risk of injury, close supervision is necessary when this
product is used near children.
9). Do not put fingers or hands into the product.
10). Do not use this product in excess of its output rating. Overloading the output
above the recommended rating may result in a risk of fire or personal inJury.
11). Switch off the power bank when not in use.
01 EN

12). The disconnection from line voltage is made by an AC plug.
13). Misuse, dropping, or excessive force may cause product damage.
14) The power supply is not intended to be repaired by service personnel in
case of failure or component defect (the product can be disposed of)
15). Do not disassemble this product Take it to a qualified service person
when service or repair is required Incorrect reassembly may result in a risk of
fire or personal injury.
16) Have servicing performed by a qualified repair person using only
identical replacement parts This will ensure that the safety of the product is
maintained.
17) If this product is not used for long periods of time, you should charge and
discharge it once every three months.
18). In normal conditions, the battery performance will decline over several years .
19) If you want to clean the product, only use a dry cloth or brush.
20).Do not clean this product with harmful chemicals or detergents.
21). Naked flame sources, such as candles, must not be placed on the product.
22) Do not expose this product to rain or snow.
23). Do not expose a power pack to fire or excessive temperature. Exposure
to fire or temperature above 100°C may cause explosion .
24). Store this product in a cool and dry place.
25). Do not store this product in a hot or humid environment
26). In case of broken cords or plugs, the product must be disposed of.
27). Do not dispose of this product in heat or fire.
28) When disposing of secondary cells or batteries. keep cells or batteries of
different electrochemical systems separate from each other.
29) Be aware that a discharged battery may cause fire or smoke.
30). CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
31) WARNING: The batteries (battery pack or installed batteries) shall not
be exposed to excessive heat such as from sunshine or fire .
32) A battery subjected lo extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in compliance
EN 02