37mm
20mm
37mm
35mm
35mm
Elevator
Rudder
Aileron
Adjust the control throws as shown in the
diagram. These throws are good for general
flying.You can adjust according to your
Personal Preference.
20mm
C.G.
130mm
5.1in
The ideal C.G. position is 130mm ( 5.1in )behind
the leading edge. In order to obtain the
C.G.specified ,add weight to the fuselage if
required. Check the C.G. Before flying.
INDEXINDEX
BEFORE YOU BEGIN BEFORE YOU BEGIN
PARTS LISTPARTS LIST
ASSEMBLYASSEMBLY
SAFETY PRECAUTIONSSAFETY PRECAUTIONS
P.1P.1
P.2-P.3P.2-P.3
P.4-P.10P.4-P.10
P.10P.10
BEFORE YOU BEGIN
1Read through the manual before you begin ,so you will have an overall idea of what to do.Read through the manual before you begin ,so you will have an overall idea of what to do.
2Check al prts.If you find anky defective of missing parts contact your local dealer.Check al prts.If you find anky defective of missing parts contact your local dealer.
3Symbols used throughout this instruction manual comprise of the following: _Symbols used throughout this instruction manual comprise of the following: _
Warning!Warning!
Apply epoxy glue.
Sides the same way.
Assemble left and right
Peel off shaded portionPeel off shaded portion
Covering film.Covering film.
3mm
Drill holes with the specifiedDrill holes with the specified
Dameter(here:3mm)Dameter(here:3mm)
Pay close attention here!Pay close attention here!
Apply instant glue
(C.A.glue,super glue. )
Apply instant glue
(C.A.glue,super glue. )
Ensure smooth non-binding
movement while assembling.
Ensure smooth non-binding
movement while assembling.
Cut off shaded portion.Cut off shaded portion.
Must be purchased separately!Must be purchased separately!
Do not overlook this symbol!Do not overlook this symbol!
P.1
F-6-F
P.10
Cont orl Ran ge s
19
C.G. Poi nt
20
# First time flyer should never fly by himself/herself.Assistance from experienced flyer is
absolutely necessary.
# Pre-flight adjustment must be done before flying,it is very dangerous to fly a badly
Pre-adjusted aircraft.
# F-6-F
Is designed to be powered engine
4c-52-63 out brush less electric motor.
using a more powerful engine does not mean better performance.In fact,over powered
engine may cause structural damage and injuries
# Make sure the air field is spacious,never fly the plane too close to people and never get
too close to a running propeller.
# If you find wrinkles on the covering as a result of weather changes,you can use hot iron
to remove the wrinkles.Please begin with lower temperature setting and gradually raise
the temperature until the wrinkles are gone.Too hot an iron may damage the covering.
# Check and re-tighten up all factory assembled screws,use thread locker if applicable.
Warning
Important Safety Precautions
