Argos 875/4334 User manual

2 Tier Chrome Shoe Rack
Dimensions
Width - 62/111.5cm
Depth - 24cm
Height - 37cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Assembly Instructions - Please keep for future reference
875/4334

• Check you have all the
components and tools listed on
pages 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts are a choking hazard.
• Make sure you have enough
space to layout the parts before
starting.
• Assemble on a pad to
avoid damaging the unit
or your floor.
•Dispose of all packaging
carefully and responsibly.
1
Safety and Care Advice
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre. 
Care and maintenance
Tube x 4 (60cm)
1
Tube x 4 (60cm)
2
Side x 2 (24x37cm)
3
Tube clamp x 4
4End cap x 4
5
Components - Panels
Please check you have all the panels listed below
Important - Please read these instructions fully before starting assembly

2
a:
b:
3
c:
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Components - Fittings
Please check you have all the fittings listed below
If you have damaged or missing components,
call the Customer Helpline: 08456 400800
Tools required
Phillips screwdriver
(medium & large)
26mm Screw x 8
A
Assembly Instructions
Step 1
b: Carefully fit the Tube
clamps onto the ends
of assembled Tubes.
Align the screw with the
hole in the tube, then
tighten the clamp enough
to hold it in position,
while still allowing the
inner tube to slide.
c: Firmly insert End caps
into the ends of the
Sides .
.
11
1
1
4
5
5
5
2
2
4
5
3
2
Finishing the Tubes
a: Slide tubes into
Tubes

b:
a:
Assembly Instructions
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Step 2
Finishing the Unit
a: Use Screws to fix
the Sides onto the
Tubes. With help, place
the unit in the intended
position.
b: Set the width of the unit
using the Tube clamps
. Loosen all 4 clamps.
Slide the tubes to the
desired width and tighten
the clamps to fix in
position.
A
A
A
A
A
A
A
A
A
A
A
A
A
A
Adjustment Range:
62-111.5cm.
Assembly is complete.
3
44
3
3