Argos HOME User manual

If you need help or have damaged or missing parts,call the Customer Helpline: Argos=03456 400800
Issue 1 - 04/09/16
45 cm
30 cm
90 cm
SLIMLINE METAL WINE RACK-24 BOTTLES
543/4176

Safety and Care Advice
Important - Please read these instructions fully before starting assembly
1
Care and maintenance
Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
From time to time check that
there are no loose screws on
this 6-tier shelf.
This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints

Components - Shelf
Please check you have all the fittings listed below
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
Metal leg X 4 (2.5x 88.1cm)
1Wine shelf X 6 (45x30cm)
2
If you have damaged or missing components,
call the Customer Helpline:
A
Plastic locking caps x 48
Anchor x 2 Screw x 2
Washer x 2
2
Argos=03456 400800
BB
AA
CC
Tools required
Phillips screwdriver
(medium & large)
Small
hammer
Drill Eye protection
(when using a
hammer or glue)
Suitable drill bit
(for use with wall plug)

TO
P
TOP
Alineadas
TO
P
TOP
Alineadas
TO
P
TOP
Alineadas
Assembly Instructions
Step 1
Attaching wine shelf
Attaching wine shelf
Attach plastic locking
caps on to the metal
leg as shown in fig 1.
Slide down base wine
shelf until it locks
over plastic locking
Push shelf firm to secure.
caps .
Step 2
Measure positon of
mid shelf required by
counting rings up from
base shelf.
Fit plastic locking caps
as shown in fig 2
Ensure all caps are fitted
to same height.
Slide down wine shelf
until it locks over plastic
locking caps
3
A
A
2
A
2
A
A
fig 1
fig 2
1 1 1
2
1
A
1 1 1
2
1
1

Assembly Instructions
Step 3
Step 4
fig 3
fig 4
4
TO
P
TOP
Alineadas
TO
P
TOP
Alineadas
TO
P
TOP
Alineadas
TO
P
TOP
Alineadas
A
A11
2
1
1
11
2
1
1
Repeat step 2 for the fourth
wine shelf as desired.
Repeat step 2 for the third
wine shelf as desired.
1
1
Attaching wine shelf
Attaching wine shelf

TO
P
TOP
Alineadas
TO
P
TOP
Alineadas
TO
P
TOP
Alineadas
TO
P
TOP
Alineadas
Assembly Instructions
Step 5
Step 6
fig 5
fig 6
5
A
A
1
1
2
2
1
1
Repeat step 2 for the last
wine shelf as desired.
Repeat step 2 for the fifth
wine shelf as desired.
1
1
Attaching wine shelf
Attaching wine shelf

Assembly Instructions
Rack now fully
assembled.
Adjust feet for correct
level.
Step 7
Step 8
Adjust feet
for correct level.
fig 7
fig 8
6
If you need help or have damaged or missing parts,call the Customer Helpline: Argos=03456 400800
CABC AB
Fixing to wall:
This step is REQUIRED to
ensure the stability of the
item.
Mark fixing hole on wall and
remove the shelf
Using a 1/4-in. drill bit
(not included), drill a 1/4-in.
pilot hole at marked
locations.
Insert anchors (BB) into
the holes, then move the
item back into position.
Insert thescrews (CC)
through washers (AA) and
the shelf (A),then into the
anchors (BB).
Warning:
Before drilling,check wall for
hidden pipes and cables.
Note:
Wall plugs supplied
are for solid wall only.
The correct type of
fixing must be used
for your wall,seek
professional
advice if in doubt

7
A Guide to - Wall Mounting & Fixings
Important note:
Types of walls
Care &
Maintenance
No.1 “General Purpose ” wall plug
No.6 “Shield Anchor ” wall plug
Heavy loads
No.3 “Cavity Fixing ” wall plug
No.4 “Cavity Fixing -Heavy Duty ”
wall plug
No.5 “Hammer Fixing ” wall plug
No.2 “Plasterboar d” wall plug
Generally aerated blocks should not
be used to support heavy loads, use
a specialist ftting in this case. For light
loads, general purpose wall plugs can
be used.
For use with heavier loads such as TV
& HiFi speakers and satelite dishes etc.
For use with plasterboard partitions or
hollow wooden doors.
For use when ftting or supporting
heavy loads such as shelving, wall
cabinets and coat racks.
For use with walls stuck with
plasterboard. The hammer fxing allows
it to be fxed to the wall rather than the
plasterboard. Always check the fxing
is secure to the retaining wall.
For use when attaching light loads on
to plasterboard partitions.
Safety : Always check the ftting
and location to ensure your safety
in and around the home.
Fitting: From time to time check
the ftting to ensure the wall plugs
or screws do not become loose.
You can use one of the following types of wall plug if your walls are made
of brick, breeze block, concrete, stone or wood.
Important: When drilling into walls always
check that there are no hidden wires or pipes etc.
Hints:
1: General rule : Always use a larger screw and wall plug
if you are not sure.
2: Ensure you use the recommended drill bit to match the wall
plug and hole size.
3: Ensure you drill the hole horizontally, do not force the drill or
enlarge the hole.
4: Take extra care when drilling high walls, ceilings and ceramic
tiles. Ensure wall plugs are inserted beyond the thickness of
the ceramic tiles to avoid the tiles splitting or cracking.
5: Ensure wall plugs are well ftted and are a tight ft in the
drilled hole.
If plastic wall plugs
are supplied with your
product:
Make sur e that the screws and wall plugs being used
are suitable for supporting your unit. Consult aqualifed
tradesperson if you ar e unsure .
- these are only suitable for
use in masonry walls.
If you are in any doubt about
the correct wall plugs for
your wall, seek professional
advice.
Failure of the product due to
using incorrect fxings is the
responsibility of the installer.