Aries 2074106 User manual

PAGE 1 • 2074106-INS-RB• 877.287.8634 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To protect the product, wax after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may
contain abrasives that could damage the finish.
For black finishes, mild soap may be used to clean the product.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Level of Difficulty
Easy
Scan
for helpful
install tips
Front
Rear
INSTALLATION MANUAL 2074106
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.
Tools Required
Ratchet Torque wrench
Socket, 13mm Level
Flathead
screwdriver
Parts List
1Driver / left rocker step
1Passenger / left rocker step
8Clip nut, M8
8 Hex bolt, M8 - 1.50 x 30mm
4Bolt plate, M8
12 Flat washer, M8
12 Lock washer, M8
4Hex nut, M8
4Bolt retainer, plastic

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 877.287.8634 • 2074106-INS-RB• PAGE 2
Step 1
Starting on the driver side, locate
the three mounting locations
underneath the vehicle.
Step 2
Remove the two hole plugs.
Insert a clip nut through the access hole
and align it over the adjacent smaller
hole. Insert a second clip nut over the
lower mounting tab.
Repeat this step for the
middle mounting location.
Step 3
Locate and remove the two hole plugs
located along the edge of the vehicle
and on the inner rocker panel.
Insert an M8 bolt into each mounting
hole. Slide a plastic bolt retainer over
the thread of each bolt to hold the bolt
in place.
Step 4
With help, lift the rocker step into
position and align the brackets on
the rocker step with the mounting
points on the vehicle.
Secure the front and middle mounting
brackets with two M8 hex bolts, two
lock washers and two flat washers.
Secure the rear mounting bracket with
two M8 hex nuts, two lock washers
and two flat washers.
Tighten all hardware to the
recommended torque specifications
listed in the table on the first page.

PAGE 3 • 2074106-INS-RB• 877.287.8634 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Step 5
Repeat steps 1 through 3 on the
passenger side of the vehicle.
Congratulations on the installation
of your new ARIES rocker steps.
With the rocker steps installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on
the first page of this instruction manual.