Aries 2057975 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8634 •2057975-INS-RB•PAGE 1
INSTALLATION MANUAL 2057975
Level of Difficulty
Easy
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes,
polish may be used to clear small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Product Registration
CURT Group stands behind our products with industry leading warranties.
You can help us continue to improve our product line and help us understand
your needs by registering your purchase by visiting:
warranty.curtgroup.com/surveys
At CURT Group, customer is king. We value your feedback and we use that information to make
improvements on our products. Please, take a minute and let us know how we are doing.
This is the second of two manuals
required to complete this installation.
The first manual is included with
your mounting brackets.
Parts List
1Driver / left
AscentStep™running board
1Passenger / right
AscentStep™running board
8Mounting plate
Attachment hardware is supplied with the
mounting brackets. Hardware quantities will
vary depending on the vehicle application.
Torque Specifications
Metric
M6 bolt 3 ft-lbs.
M8 bolt 7 ft-lbs.
M10 bolt 16 ft-lbs.
M12 bolt 28 ft-lbs.
SAE
1/4" bolt 3 ft-lbs.
5/16" bolt 7 ft-lbs.
3/8" bolt 16 ft-lbs.
7/16" bolt 20 ft-lbs.
1/2" bolt 28 ft-lbs.
Use above torque setting unless otherwise noted
Tools Required
Ratchet set Torque wrench
This is the second of two manuals
required to complete this installation.
The first manual is included with
your mounting brackets.
Product Photo
Front
Rear

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •877.287.8634 •2057975-INS-RB•PAGE 2
Step 1
Place the mounting plates into
the track on the running board.
Carefully place the running board
onto the mounting brackets.
Slide the mounting plates along
the track to align with the mounting
brackets on the vehicle.
Secure the running board to the mounting
brackets using two M8 hex bolts, two
lock washers and two flat washers.
Note: The number of mounting brackets
may vary based on application. Use one
mounting plate per bracket.
Step 3
Repeat all steps for the
passenger side of the vehicle.
Congratulations on the installation of your
new ARIES AscentStep™running boards.
With the running boards installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on the
first page of this installation manual.
Representative Image
Mounting plate
Mounting
plate
M8 hex bolt
M8 flat washer
M8 hex bolt
M8 flat
washer
M8 flat washer,
lock washer
Step 2
At this time, adjust the running board to the desired location.
With the running board in position, it is recommended to tighten all
brackets to the vehicle first, followed by the running board connections.
For recommended torque specifications, refer to the table on page 1.