Aries 2081101 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •RA •PAGE 1
INSTALLATION MANUAL
Torque Specifications
M6 bolt 7 ft-lbs.
M8 bolt 16 ft-lbs.
M10 bolt 33 ft-lbs.
M12 bolt 58 ft-lbs.
Use above torque setting unless otherwise noted
Tools Required
Ratchet Phillips screwdriver
Socket extension Flathead screwdriver
Socket set Allen wrench set
Level Box wrench set
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Product Photo
Applicable to the Following Part Numbers
2081101 2081100
Product Registration
CURT Group stands behind our products with industry leading warranties.
You can help us continue to improve our product line and help us understand
your needs by registering your purchase by visiting:
warranty.curtgroup.com/surveys
At CURT Group, customer is king. We value your feedback and we use that information to make
improvements on our products. Please, take a minute and let us know how we are doing.
This is the third of three manuals
required to complete this installation.
The first manual is included with
your center section. The second manual
is included with your bumper corners.
ANGULAR
BRUSH GUARD
Parts List
1Angular brush guard
6Buttonhead cap screw, M6
12 Flat washer, M6
6Nylock nut, M6
4Hex bolt, M10
8Flat washer, M10
4Lock washer, M10
4Nut, M10
1Cover plate
Level of Difficulty
Easy

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •RA •PAGE 2
Step 1
Place the cover plate on top of the brush guard.
Insert an M6 button head cap screw with flat
washer and secure with a nylock nut.
Repeat for all six attachment points.
Adjust if necessary and fully tighten
all hardware with an Allen wrench.
Step 2
Place the center section onto a flat work
surface. Lift the brush guard into place and
insert and M10 hex bolt with locking and flat
washer. Secure the bolt with a second
flat washer and a hex nut.
Repeat this for all four attachment points.
Adjust if necessary and fully tighten all the
hardware with a 16mm socket and wrench.
Note: To finish the installation,
continue to step 7 of the manual
included with your center section.