Aries 2074120 User manual

PAGE 1 • 2074120-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
For black finishes, mild soap may be used to clean the product.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Level of Difficulty
Easy
Parts List
1Driver / left side rocker step
1Passenger / right side bar
18 Flat washer, M8
18 Lock nut, M8
18 Plastic spacer, M8
Tools Required
Torque wrench Extension
Socket, 13mm
Scan
for helpful
install tips
Front
Rear
INSTALLATION MANUAL 2074120
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2074120-INS-RA • PAGE 2
Step 4
Repeat steps 1 through 3
on the passenger side of the vehicle.
Congratulations on the installation
of your ARIES rocker steps.
With the rocker steps installed,
periodic inspections should be
performed to ensure all mounting
hardware remains tight.
Step 1
Starting on the driver-side,
locate the three mounting locations
underneath the vehicle.
Step 2
Place plastic spacers on the M8 tabs
With help, lift the driver-side rocker step
up to the vehicle. Align the mounting
holes on the rocker step with the
mounting points on the vehicle.
Step 3
Secure the rocker step to the
vehicle using two M8 lock nuts
and two M8 flat washers.
Repeat step 2 and the above
process to secure the middle
and rear mounting brackets.
With the rocker step in position,
tighten all mounting hardware to the
recommended torque specifications
listed in the table on the first page.