Aries 2074111 User manual

PAGE 1 • 2074111-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
For black finishes, mild soap may be used to clean the product.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Level of Difficulty
Easy
Parts List
1Driver / left rocker step
1Passenger / right rocker step
12 Hex bolt, M8
12 Flat washer, M8
12 Lock washer, M8
6Hex bolt, M10
6Flat washer, M10
6Lock washer, M10
6Bolt, M12 / Nut, M10 plate
6Flat washer, M12
6Lock washer, M12
6Hex nut, M12
Tools Required
Torque wrench Extension
Socket, 13mm Socket, 18mm
Socket, 16mm
Scan
for helpful
install tips
Front
Rear
INSTALLATION MANUAL 2074111
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2074111-INS-RA • PAGE 2
Step 1
Starting on the driver-side, locate
the three mounting locations
underneath the vehicle.
Step 2
Using a utility knife, cut and remove the
tape plug covering the third mounting
point for the front mounting bracket.
Step 3
With help lift the board and align the
front bracket with the mounting locations
and secure it with an M12 hex nut,
lock washer, flat washer and either
two M8 hex bolts, lock washers and
flat washers, or an M10 hex bolt,
flat washer and lock washer.
Note: On vehicles not equipped with
M8 threaded inserts, align the M10 nut
on the M12 bolt plate with either hole
location on the bracket. Secure using
an M10 hex bolt, lock washer and
flat washer.
Step 4
Repeat steps 2 and 3 to secure the
middle and rear mounting bracket.
Tighten all hardware.

PAGE 3 • 2074111-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Step 5
Repeat steps 1 through 4 on the
passenger side of the vehicle.
Congratulations on the installation
of your new ARIES rocker steps.
With the rocker steps installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.