Assa Abloy EMTEK A User manual

OOR
OOR
HOLE PREPARATION

OOR
OOR
IN4-MORTISE-R 15C

nstallation Guide - F13 MortiseLock
Platesandgripvarydependingonstyle.
IN4-MORTISEINSTF13 REV15A
Assembleto
bottomtube
See templatefordoorprep
2.InstallMortise Lock1.Install CylinderPlug
Outside nside
3.MountInside andOutsideTrimtoDoor
nstall key 3/4 of the way into
the key cylinder and thread
it clockwise onto trim plate.
nstall cylinder plug by
threading it clockwise
onto lock body
4.Install KeyCylinder
After key cylinder is installed,
secure cylinder by tightening
screw
6.Install TrimPlate
TightenLeverwith3/32
Hexwrench(provided).
See templatefordoor 2.Pull outand rotate
Latch bolt toreverse
itsdirection.
1.Removedowel
screw. (Replace
afterreversing
swing)
Note: Notch on cylinder
plug must be in the 9
o’ clock position when
fully screwed onto lock
body.

nstallation Guide - F20 MortiseLock
Platesandgripvarydependingonstyle.
IN4-MORTISEINSTF20 REV 15A
Assembleto
bottom tube
See templatefordoorprep
2.InstallMortise Lock1.Install CylinderPlug
Outside nside
3.MountInside andOutsideTrimtoDoor
nstall key 3/4 of the way into
the key cylinder and thread
it clockwise onto trim plate.
nstall cylinder plug by
threading it clockwise
onto lock body
4.Install KeyCylinder
After key cylinder is installed,
secure cylinder by tightening
screw
6.Install TrimPlate
TightenLeverwith3/32
Hexwrench(provided).
Seetemplatefordoor Thumbpress
Locked
Thumbpress
Unlocked
In In
2. Pullout and rotate
Latchbolt toreverse
itsdirection.
1.Remove dowel
screw.(Replace
afterreversing
swing)
Note: Notch on cylinder
plug must be in the 9
o’ clock position when
fully screwed onto lock
body.