Assa Abloy SARGENT 115 Hospital Latch User manual

1-800-727-5477 • www.sargentlock.com A5735L 4/20
Copyright © 2019, 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in
whole or in part without the express written permission ofSARGENT Manufacturing Company is
prohibited.
Installation Instructions
WARNING
This product can expose you to lead
which is known to the state of California
to cause cancer and birth defects or other
reproductive harm. For more information go
to www.P65warnings.ca.gov.
115 Hospital Latch
Specialty Hardware
Attention Installer
Please read these intructions carefully to prevent missing important steps.
Note
• Improper installation may result in damage to lock and void factory warranty.
• Other product brand names may be trademarks or registered trademarks of their respective owners and
are mentioned for reference only.
• Handle units are factory assembled for either right or left hand doors. Be sure to use correct hand to
match door application.

1-800-727-5477 • www.sargentlock.com A5735L 4/20
Copyright © 2019, 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in
whole or in part without the express written permission ofSARGENT Manufacturing Company is
prohibited.
SARGENT Manufacturing Company
100 Sargent Drive
New Haven, CT 06511 USA
800-727-5477
www.sargentlock.com
The ASSA ABLOY Group is the global
leader in access solutions. Every day
we help people feel safe, secure and
experience a more open world.
• Prepare door according to
template.
• Place latch case in door with
bolt bevel facing the direction of
door closing. Screw front into
place.
• Mount fire shields to door, using
two 4-40 screws provided. Use
two 3/8“ x 1“ long screws for
1-3/4“ doors. Use two 7/8“ x 1“
long screws for 2-1/4“ doors.
• Position handle units so that
location pin and cam arm enter
into corresponding holes in
latch case and fire shields.
• Line up edge of chassis parallel
to edge of door, using a level.
• Mark location of mounting
screws. Use a 1/8“ (maximum)
pilot drill before applying four
#12 X 1“ flat phillips head
mount screws. Repeat proce-
dure for opposite handle unit.
• Apply covers and fasten to
chassis with the two screws per
cover provided. Tighten screws
evenly on each side of cover so
that handle does not touch side
of hole.
Installation
1