Assa Abloy SARGENT 1655 User manual

FOR ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com
Installation
Insert locker lock into prepared door and secure with 4 screws provided.
For doors less than 1-1/2" thick use 1/8" spacers provided on doors down to 1" thick to conceal cylinder
retaining set screw. Secure strike with screws provided.
Re-pinning instructions
2. To re-pin cylinder remove lock from door.
Using 2 mm Allen wrench remove cylinder retaining set screw as shown.
Insert key and turn 90º CW and remove key to extract cylinder and retainer from lock.
Remove retainer from cylinder and re-pin as typical dead bolt cylinder.
Reverse steps to reassemble.
INSTALLATION INSTRUCTIONS
for 1655 Locker Lock
Be sure set screw is not
exposed after assembly
to door
Tools
#2 Phillips Head Screwdriver
Door Preparation
1. Prepare reinforced door and frame to template 4696.
2 mm
Copyright © 2011, Sargent Manufacturing
Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in
part without the express written permission of
Sargent Manufacturing Company is prohibited.
A8101:A 3-15-11
A8101A.indd 1 3/28/11 12:19:25 PM

A8101A
Copyright © 2011, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
11
4
"
21
64
"
119
32
"
3
16
"
33 64
"
STRIKE DIMENSIONS
1 8
"
11
16
"
19
16
"
15
32
"
THRU HOLE
1 8
"
2X TAP FOR A #6 x 5/8" PHILLIPS C'SUNK COMBINATION SCREW
4X TAP FOR A #8 x 1-1/4" COMBINATION SCREW INSIDE OF DOOR ONLY
FRAME
3
16
"
11
32
"
17 32
"
21
32
"
119
32
"
11
2
"
2"
11
16
"
19
16
"
11
8
"
15 16
"
4X
11 64
"
1"
LOCKER LOCK DIMENSIONS
1 8
"
PLASTIC PAD
STRIKE
BOLT
OUTSIDE OF DOOR
FRAME
1 2
"
3
16
"
19
16
"
TEMPLATE/DATA SHEET 1655 Locker Lock Flush Mount Application 4696A
A8101A.indd 2 3/28/11 12:19:25 PM