Atmos S 201 Thorax User manual

Quick Guide ATMOS®S 201 Thorax
This Quick Guide does not replace the operating instructions. Icons
Always carry out steps 1 - 6 under sterile conditions. Information Warning!
Set up and switch on
click
1. If necessary fi ll the water
lock
2. Connect canister to device
3. Connect secretion channel
of hose system to secretion
canister
4. Connect measuring-/
rinsing channel of hose
system to device
Do not overtighten the
Luer-Lock connections!
5. Adapt the connector of
hose system to hose end at
patient side
Check the Luer-Lock cap of
connector for tightness!
6. Cover the connector

7. Switch on the device Leakage test starts
automatically!
8. Only proceed if the leakage
test is passed!
Only proceed shortly
before patient is
connected!
9. Start a new therapy or
continue with the existing
therapy

1
2
5
3
41Actual vacuum
2Target vacuum
3 Current fl ow value
4Therapy progress
5User settings
10. Set target vacuum with + / - 11. Adapt the connector to
patient catheter
12. Start therapy
Exchanging secretion canister
1. Prepare a new secretion
canister
2. Clamp the patient catheter
Do not clamp the hose
system!
3. Deactivate the keylock
4. Stop therapy
5. Remove secretion channel
of hose system from
secretion canister
6. Remove measuring-/
rinsing channel of hose
system from device

1
32

1
2
click
7. Remove secretion canister 8. Cover pop-off -valve and secretion channel with appropriate
covering caps
9. Dispose of correctly
10. Connect a new secretion
canister
11. Connecting the hose system 12. Start therapy again
Wait until the actual vacuum
corresponds to the target
vacuum!
13. Remove the clamp from
patient catheter
Warning messages
In the event of a fault, warning messages will sound. Error cause and troubleshooting are displayed, e.g.
Vacuum too low
Check the following components for leakage and if applicable correct attachment:
»Connection from hose system to
patient catheter
»Connection from secretion channel to
secretion canister
»Connection from measuring-/rinsing
channel to canister system
»Secretion canister connection
Check the following components for blockages and if applicable exchange:
»Bacterial fi lter in canister system »Hose system »Kink in hose system
Explanatory video: https://youtu.be/XQBz2H7piKg
E-Mail: [email protected]
GA2GB.710201.0 2017-12 Index: 02

www.atmos-thorax.com