AUTLED LC-002-060 User manual

LED RF Controller RGB Set - User Manual
Item No.: LC-002-060
1. Product Introduction
2. Performance Parameter
The remote and it‘s receiver is a one zone RF wireless RGB Controller. The Controller can also
work with data repeater to expand output unlimitedly.
3. Features
1. Power on and power off
2. Activate a desired colour by the colour wheel
3. Activation of fixed-stored colour gradients
4. Activation of 3 fixed stored RGB white colours
5. Dimming of desired colours and colour gradients
6. Speed changing and freeze of colour gradients
7. Switch on/off and dimming of the 3 channels RGB
Operation Voltage 3x 1,5 VDC Batteries
Operation Frequency 434MHz/868MHz
Dimensions (L x W x H) 120x 47,9 x 17,6mm
Operation mode: RF Wireless
Input Voltage DC12V-DC24VDC, constant voltage
Max. Output Power 3 x 5A (180W/12V) or (360W/24V)
Dimensions (L x W x H) 144 x 46 x 17mm
Weight 75g
Remote:
Receiver:

4. Operation Manual
5. Safety warnings
5.1. To avoid installed the product in minefield, strong magnetic field and high voltage area.
5.2. To ensure the wiring is correct and firm avoiding short circuit damages to components and
cause fire.
5.3. Please install the product in a well ventilated area to ensure appropriate temperature
environment.
5.4. The product must be worked with DC constant voltage power supply.
Please check the consistence of input power with the product, if the output voltage of the
power comply with that of the product.
5.5. Connect the wire with the power on is forbidden. Ensure proper wiring first then check to
ensure no short-circuit, then power on.
5.6. Don‘t repair it by yourself whenever an error occur. Contact the supplier for any inquiry.
4.1.Connection of Remote with the Receiver:
a) Do wiring according to connection diagram
b) Wake up the remote control by touching ON/OFF button.
c) Press the „RF Code Key“ Button on the Receiver.
d) Touch the control wheel on the remote.
e) Connected LED light will blink to confirm matching successfully.
f) If you wish to delete the learned ID, please press „RF Code Key“ on the receiver for 5 seconds
until LED light flash, the the learned ID is deleted.
4.2. Description of the remote buttons:

6. Conjuction Diagram
7. Remarks
7.1. Power source must be DC constant voltage type of power supply. Due to the efficient output
in some power supplies are only 80% of total, so please select at least 20% higher output
power supply than the consumption of LED lights.