AUTLED LC-012-004 User manual

LED RF WiFi Controller Mono Remote 4 Zones - User Manual
Receiver: LC-012-004Remote: LC-012-009
1. Product Description
The RF WiFi Mono Remote can control 6 different zones. Each zone (Button 1-6) can store upto
6 different lighting moods. Brightness can be adjust over the brightness wheel.
2. Specification
2.1 Remote LC-012-009:
Operation Voltage: 4,5VDC Battery, RF Wireless, Frequenz 434MHz/869,5MHz/916,5MHz
2.2 Receiver LC-012-004:
12-36VDC Input Power, 4 channels x 8A, constant voltage, 4 channels x (96-192)W
Important: With the Remote you can control the receiver LC-012-004. Thus, the receiver can be
controlled by software and remote control.
3. Wiring Diagram

5. Operation Instructions
1. Do wiring according to connection diagram
2. Pairing of Remote and Receiver:
a. Turn on the Remote with ON/OFF Button
b. Press the Learning Key on the Receiver
c. Press any zone button on the remote control
d. Then touch the brightness wheel
e. The connected LED light will blink to confirm the zone designation
f. If you wish to delete the pairing, pls press the Learning Key over 3 seconds on the receiver
until the LED light flash up.
Important: Each remote control 6 zones (areas) receivers, each area can be learned as many
receivers as we can. Each receiver maximally can be controlled by 8 different remote controls.
3. Dim wheel function
Choose a zone with the zone buttons for exampel zone and zone .
thereafter choose with the brightness wheel dthe desired brightness. The selected
brightness will be indicated in zone and .
4. Introduction of Buttons
Indicator
Dimming Button Brightness wheel
25% Brightness
100% Brightness
75% Brightness
Save Buttons
ON/OFF for all zones
50% Brightness
Zone Buttons

4. brightness up/down button
Long press brightness button to dim down/up the brightness, the dimming direction will
change every time after pressing switch. For example, the first long press is brigthness up,
it will be dimmed down when long press again.
5. Brightness level button
Select a zone with zone buttons for example zone and zone .
Short press button , , or uhe corresponding zones will be
25%, 50%, 75% or 100% brightness (which one is selected).
6. Save and recall button
Save color temperature:
Select a zone with zone buttons , thereafter choose a brightness/dimming
with the brightness wheel Then press one of the save buttons for 2-3 seconds.
The LED lighting flash twice indicate save is successful.
Recall of selected brightness/dimming in a zone:
Select a zone with zone buttons , thereafter short press a save button
which you stored before.
The adjusted brightness/dimming will be recalled in the selected zone.
1. To avoid installed the product in minefield, strong magnetic field and high voltage area.
2. To ensure the wiring is correct and firm avoiding short circuit damages to components and
cause fire.
3. Please install the product in a well ventilated area to ensure appropriate temperature
environment.
4. The product must be worked with DC constant voltage power supply.
Please check the consistence of input power with the product, if the output voltage of the
power comply with that of the product.
5. Connect the wire with the power on is forbidden. Ensure proper wiring first then check to
ensure no short-circuit, then power on.
6. Don‘t repair it by yourself whenever an error occur. Contact the supplier for any inquiry.
6. Safety warnings