Avlite AV-70 User manual

For the full manual, visit the link below:
avlite.com/product/aviation-and-taxiway-light-faa-and-icao-av-70
Quick Start Guide Thank you for purchasing this product. This guide will
provide you with a brief summary of the steps involved in
deploying the AV-70
This Quick Start Guide provides a summary of installation steps for the AV-70 Solar Aviation Light. A thorough review
of the Installation and Service Manual is recommended prior to installation.
Note: The AV-70 can be operated as a solar or AC powered aireld light. Lights can be operated without cabling,
using solar power. Cables can be used for sustained operations (greater than 20 hours), in conditions of low sunlight
and/or low temperature.
Before installation, ensure that applicable power systems have been installed if required by your specic ligthing
system installation
If required, please consult the AvMeshTM RF Communications Manual and Quick Start Guide to program light groups.
What Installation Parts will you need?
Mounting Tile (if required) 1
Large Washers 2
Quick Release Pins - Long (for tile mounting only) 2
Frangible Concrete Mount (if required) 1
Frangible Stake Mount (if required) 1
AV-70 Aviation Light
Step 1: Remove Bung
Using a bung tool, remove the bung from the bottom
of the light base.
Note: There is a sealed vent on base which allows air
transfer without moisture intake. Do not disturb.
Step 2: Charge the battery
New lights should be left in the sun for several days
to ensure the battery is charged before placing in
service.
Step 3: Activate Light
Set internal toggle switch to ON. Replace bung in light
base. Alternatively ick the external switch to 'ON' if
tted
Note: Power and range settings are factory-set
by Avlite to comply with regulatory or customer
requirements.

Head Oce
[phone]
Avlite USA
[phone]
Avlite Asia
[phone]
General Enquiries
[email protected]
Step 4: Install AV-70 Fixtures
The AV-70 is able to be installed on any appropriately
reinforced mounting point with a 200 PCD. Alternatively,
the xture can be installed on the Avlite supplied Mounting
Tile, Frangible Stake Mount or Frangible Concrete Mount.
Step 5: For RF enables xtures: Use RF
Controller to test the system
Please consult the AV-70 Manual or the AvMeshTM Quick
Start Guide for details on how to test the system.
Step 5: Connect the lights
Please consult your Lighting System Manual.
Step 6: Perform X Action
• For RF enabled variants, use the RF controller to
test the system
• For PLC enabled variants, use PLC controller to test
the system as specied by your Lighting System
Manual
Wireless Deployment: Wired Deployment:
NOTE:
For best light performance,
ensure solar modules are
not covered and are in clear
view of the sky with no
shadows
Mounting Tile Frangible Concrete
Mount Frangible Stake
Mount