FMS-QS Quick Setup Sheet
Step 1:
Choose either the spike feet or the rubber feet and attach
those on the base. Spikes or feet make absolutely no
difference in sound quality. They are supplied for your
convenience or stability only.
Step 2:
Locate the two round pillars with the threaded end and
screw the threaded end carefully into the metal pedestal
base, rotating the pillar in a clockwise direction. Tighten
pillars right down as snugly as you can.
Step 3:
Now you can run the speaker cable through one of the
pillars and out the top to connect to the speaker later
on.
Step 4:
Now place the collars on top of the pillars but do not
tighten the set screw. At this time set screws should be
facing the rear of the stand. Speaker wire should be
placed in one of the collar notches.
Step 5:
Attach the platform to the top of the
metal collars (ensure that the metal
lips of the plate face upward) using
the six supplied screws.
Step 6:
Now tighten the collar set screws.
Step 5
Platform To Collar Screws
Visit www.axiomaudio.com/manual_index.html for full owners manual
Platform To Collar Screws
Step 6
Step 3
Pillar
Step 2
Step 1
Collar
Pedestal Base
Spike x 4
Rubber Foot x 4
Collar Set Screw
Collar Notch
Step 4
Speaker Wire
Step 1
