Axiom SW18P User manual

USER MANUAL
SW18P
passive subwoofer
KEY FEATURES
• High power compact subwoofer • Pole mount socket
• 18” woofer, 4” voice coil • Heavy duty wheels
• Water repellant cone
INTRODUCTION
The SW18P is a high-power compact subwoofer that provides extended low
frequency response for specic models in the ED series of high performance
point source loudspeakers. It is suitable for the use in live music venues,
nightclubs, barss houses of worship and for corporate and A/V applicaons.
The SW18P subwoofer system is equipped with a high power 18” (460mm)
transducer capable of long excursion (up to 30mm peak-to-peak), controlled
by high sness Double Silicon Spider as centering suspension that maintains
linear voice coil travel even at high output levels. The motor structure features
high strength (BL²/Re) with opmized symmetry and excursion controlled by
Inner Flux Demodulang Ring. The robust copper 100mm (4”) voice coil is
wounded in two dierent layers both outside and inside the coil support, then
doubling the coil surface exposed to air cooling and consequently improving the
long term thermal capacity of the loudspeaker. Cones are made of very high-
sness glass ber reinforced paper, featuring also invisible water repellent
treatment.
The 15mm phenolic birch plywood cabinet is provided with an M20 pole mount
socket to allow two-way ED series loudspeakers to be mounted above on a
speaker pole. Recessed handles are provided for easy liing and handing and
the included polyurethane wheels aid transportaon, while stacking feet and
matching recesses enable secure ground stacks. Two Neutrik® speakON™ NL4 connectors provide input and link connecons.
TECHNICAL SPECIFICATION
Acouscal Connectors
System type Bass-reex Connector Type Neutrik® Speakon® NL4 x 2
Transducer
18” (460 mm), 4” (100 mm) VC 8 ohm,
High sness, water repellent, glass bre
reinforced cone
Flux Demodulang Ring VC
Double Centering Spider Suspension
Input Wiring Pin 1+/1-; (Pin 2+/2- pass thru)
Mechanical
Width 650 mm (25.6”)
Height 500 mm (19.7”)
Depth 564 mm (22.2”)
Frequency response (±3 dB) 36 Hz – 100 Hz (Processed) Depth Including Wheels 672 mm (26.5”)
Sensivity (1.41V @ 1m, 2Pi) 98 dB Construcon 15 mm Phenolic Birch Plywood
Maximum Peak SPL @ 1m 132 dB Paint Black textured paint (or White)
Electrical Wheels 4 heavy-load 80 mm ø
Nominal Impedance 8 Ω Transport 2 handles
Minimum Impedance 6.3 Ω @ 36 Hz Net Weight 40 Kg (88.2 lbs.)
Power Handling Connuous* 1200 W
Power Handling Program 2400 W
Power Handling Peak 7000 W
Power Compression
@ -10 dB Power (240 W) = 0.7 dB
@ -3 dB Power (1200 W) = 1.5 dB
@ 0 dB Power (2400 W) = 2.2 dB
* AES Pink Noise Power
revision 2017-10-10

MECHANICAL DRAWING
OPTIONAL ACCESSORIES
NL4FX Neutrik Speakon® PLUG
see hp://www.axiomproaudio.com/ for detailed descripon and other available accessories.
SPARE PARTS
AC102GS 80 mm Swivel castor
AC115DN Black steel handle
98NEOS18SW8 18’’ woofer - 4” VC - 8 ohm
NL4MP Neutrik Speakon® panel socket
65 cm
25.6"
50 cm
19.7"
56.4 cm
22.2"
67.2 cm
26.5"
M20 Pole Adaptor

REAR PANEL
INPUT - Power input for the external amplier. The SW18P does not include a passive crossover for ltering the signal. The connecons are the
following:
INPUT - LINK
NL4 pin number internal connecon
1+ +
1- -
2+ none (pass thru)
2- none (pass thru)
LINK - Power output in parallel with the INPUT socket for connecng the unit to another speaker. The number of SW18P cabinets that can be
connected in parallel depends on the amplier load capacity.

LIMITED WARRANTY
Proel warrants all materials, workmanship and proper operaon of this product for a period of two years from the original date of purchase. If any defects are found
in the materials or workmanship or if the product fails to funcon properly during the applicable warranty period, the owner should inform about these defects the
dealer or the distributor, providing receipt or invoice of date of purchase and defect detailed descripon. This warranty does not extend to damage resulng from
improper installaon, misuse, neglect or abuse. Proel S.p.A. will verify damage on returned units, and when the unit has been properly used and warranty is sll
valid, then the unit will be replaced or repaired. Proel S.p.A. is not responsible for any “direct damage” or “indirect damage” caused by product defecveness.
• This unit package has been submied to ISTA 1A integrity tests. We suggest you control the unit condions immediately aer unpacking it.
• If any damage is found, immediately advise the dealer. Keep all unit packaging parts to allow inspecon.
• Proel is not responsible for any damage that occurs during shipment.
• Products are sold “delivered ex warehouse” and shipment is at charge and risk of the buyer.
• Possible damages to unit should be immediately noed to forwarder. Each complaint for package tampered with should be done within eight days from product
receipt.
SAFETY INSTRUCTIONS
– To reduce the risk, close supervision is necessary when the product is used near children.
– Protect the apparatus from atmospheric agents and keep it away from water, rain and high humidity places.
– This product should be site away from heat sources such as radiators, lamps and any other device that generate heat.
– This product should be located so that its locaon or posion does not interfere with its proper venlaon and heang dissipaon.
– Care should be taken so that objects and liquids do not go inside the product.
– The product should be connected to a power supply mains line only of the type described on the operang instrucons or as marked on the product. Connect the
apparatus to a power supply using only power cord included making always sure it is in good condions.
– WARNING: The mains plug is used as disconnect device, the disconnect device shall remain readily operable.
– Do not cancel the safety feature assured by means of a polarized line plug (one blade wider than the other) or with a earth connecon.
– Make sure that power supply mains line has a proper earth connecon.
– Power supply cord should be unplugged from the outlet during strong thunderstorm or when le unused for a long period of me.
CE CONFORMITY
Proel products comply with direcve 2014/30/UE (EMC), as stated in EN 55103-1 and EN 55103-2 standards and with direcve 2014/35/UE (LVD),
as stated in EN 60065 standard.
PROEL S.p.A. (World Headquarter) - Via alla Ruenia 37/43 - 64027 Sant’Omero (Te) - ITALY
Tel: [phone] Fax: [phone] www.axiomproaudio.com