Baby Lock BLES8-CST User manual

This table has additional holes to attach the Knit Woven Bias
Binder for chain/cover stitching on your Baby Lock Ovation
serger.
1. To use the Chain/Cover Stitch table for chain/cover
stitching, you will need to change the cutting blade cover
as follows:
A) Open front cover and cutting blade cover (fig. A & B).
B) Depress the center snap and gently pull toward you
to unsnap cutting blade cover (fig. C) and then snap
Chain/Cover Stitch table into place.
Alternate Chain/
Cover Stitch Table
(BLES8-CST)
Instructions
Baby Lock
Serger Accessories
(Instructions continued on back)
www.babylock.com
A
B
C

www.babylock.com
LNIS-BLES8-CST
C) Disengage the upper looper by turning the upper looper
positioning knob to “Down” (fig. D).
D) Move the stitch width adjusting dial to the 3.0 setting.
E) Turn cutting blade locking dial to “LOCK.”
F) To close the Chain/Cover Stitch table door, raise to the “Up”
position and slide to the left, placing the tab of the table
under the needle plate (fig. E).
F
D
E