BDI Sequel User manual

A - 4mm Hex L-Wrench x 1
G - 8-32 x 22mm
Phillips Screw x 4
C - 8-32 x 12mm
Phillips Screw x 20
D x 2
D - Brake Caster x 2
F x 2
F - Rear Caster x 2
B - Cabinet x 1
E - Center Caster x 1
I - 1/4-20 x 15mm
Screw x 3
J - Glass Top x 1
K - Legal File Folder
Stretchers x 4
C x 8
E x 1
C x 4
C x 8
H - Drawer Pull x 2
L - Rubber Stem Bumpers x 2
SEQUEL
Designed by Matthew Weatherly
These distinctive product configurations are protected by US and international
patents, trade dress, and/or copyright laws.
BDI are trademarks of Becker Designed, Inc.
All Rights reserved. © 2010 BDI
6005 TALL FILE PEDESTAL Revision: 04-13-2011
Component List
6005 TALL FILE PEDESTAL
ASSEMBLY INSTRUCTIONS
1
BDIUSA.COM [e-mail]
SEQUEL 6005 TALL FILE PEDESTAL is engineered for easy assembly. Carefully
follow this procedure to prevent any damage.
Placement and Maintenance
SEQUEL 6005 TALL FILE PEDESTAL is designed for indoor use on level floors.
Clean glass with glass cleaner, and wood veneer with a moist cloth.
Step 1
Unpack and Identify
Unpack and identify the components at left. Note that some components
are shipped inside the cabinet. The assembly workspace should be a nonmarring
surface such as carpet. A Phillips Screwdriver will be needed for
assembly. For missing hardware pieces, please contact BDI Customer
Service at [e-mail]. For all other concerns, please
contact your BDI Retailer.
Step 2
Install Casters
Carefully position Cabinet (B) on its top surface so that bottom surface is
up, then attach a Caster at each of the five (5) exposed installation plates
using 8-32 x 12mm Phillips Screw (C) and a Phillips Screwdriver.
FRONT

G x 4
I x 3
K
SEQUEL
6005 TALL FILE PEDESTAL ASSEMBLY INSTRUCTIONS
2 BDIUSA.COM CUSTOMERSER[email protected]
Step 3
Install Handles.
Carefully turn pedestal upright so that it
rests evenly on all installed casters, then
install one Drawer Pull (H) per drawer
using the 8-32 x 22mm Phillips Screw(G)
and a Phillips Screwdriver.
Step 4
Install Glass Top
Carefully place Glass Top (J) on pedestal’s top surface,
aligning the pre-installed pucks over the corresponding
mounting point on the pedestal. Attach Glass Top (J) by
opening drawer and fastening from underside (inside
drawer) using three (3) 1/4”-20 x 15mm Screws (I) with
provided Allen Wrench (A).
NOTE: Glass Top (J) fastens at three (3) points only---two
(2) near front edge and one (1) at center.
DO NOT OVER-TIGHTEN
Step 5
File Folders
Users who wish to use legal-length files may install provided
Legal File Folder Stretchers (K) by dropping into place near
front and back of file drawers.
H x 2
J
L - Rubber Stem Bumpers x 2
Move Levers on both
Drawer sides to
Release Drawer.
Left Side lever up.
Right Side lever down.