Belimo Clear Edge EAP005 User manual

INSTALLATION INSTRUCTIONS
Belimo Clear Edge Device
70730-00001.A
03/19 - Subject to change. © Belimo Aircontrols (USA), Inc.
INSTALLATION / MOUNTING
Front View
Side View
Rear View
Wall Mounted Option
Step 1. Mark and prep holes on surface for mounting
Step 2. Attach mounting bracket to chassis
Step 3. Fasten system to surface
DIN Rail Option
Step 1. Attach DIN rail mounting brackets to chassis
Step 2. Clip system to DIN rail
Power Connection
Connect supplied 12 VDC power adapter to approved power source.
GENERAL WARNINGS
1. Do not open or modify the device. The device uses components
that comply with FCC and CE regulations. Modication of the
device will void these certications.
2. Install the device securely. Be careful handling the device to
prevent injury and do not drop.
3. Wall or ceiling mounting device requires use of a mounting plate or
bracket. Plate or bracket must be of metal construction and have a
minimum thickness of 1mm.
4. Use M3x0.5mm Flat Head screws to attach mounting plate or
mounting brackets to threaded holes on bottom of chassis. Screws
should be minimum length of 4mm. Add 1mm of screw length
for every mm of additional thickness of plate or bracket beyond
1.5mm.
5. Operational temperature must be between 32°F-122°F
[0°C-50°C] with a non-condensing relative humidity of 10-90%.
6. The device can be stored at temperatures between 32°F-122°F
[0°C-60°C].
7. Keep the device away from liquids and flammable materials.
8. Do not clean the device with liquids. The chassis can be cleaned
with a cloth.
9. Allow at least 2 inches of space around all sides of the device for
proper cooling.

Belimo Clear Edge
2
Quick Start Guide
Quick Start instructions are intended for users that are connecting to the
Belimo Clear Edge.
Supported Hardware
– EAP005, EAP020, EAP050
Default IP Settings
– Port 1: (Congurable)
– IP Address: DHCP
– Port 2: (Service Port)
– IP Address: 100.100.1.100
– Subnet: 255.255.255.0
Default Credentials
– Administrator:
– Username: admin
– Password: Admin
– Operator:
– Username: belimo
– Password: Belimo
Application Details
The default application installed will follow a consistent naming pattern for
uniqueness. This naming convention is as follows: belimoEv<serialNumber>
The UI will display as BelimoEv without the serial number.
Changing IP Settings
1. Plug a network cable from a computer to the Service Port of the device.
Change computer network settings as appropriate to access the
application in a web browser on the IP address provided above.
2. Log in using the admin user.
3. Click the BelimoEv project, then select the IP Cong App.
Port 1
Port 2

Belimo Clear Edge
3
4. Change the IP settings for Port 1 as required and click submit.
5. Plug the device into the building’s network on Port 1.
Energy Valve Pod Introduction
Your Automated Energy Valve Application includes two Apps.
1. EnergyValveCong – Provides conguration, settings for the installer or
provider.
2. EnergyValve – Provides visualizations for the end-user.
Access to each App can be congured independently through the Host > User
View.