Better Bathrooms BeBa 27580 User manual

BACK LIT PILL SHAPED MIRROR
(500 x 800mm)
BeBa_27580
SINGLE-PERSON ASSEMBLY
LED LIGHT
IP44 INGRESS PROTECTION

SAFETY
The fitting should be installed by a qualified electrician.
This fitting is only suitable for connection to a 220V~50Hz
earthed supply in accordance with current IEE wiring
regulations, and should be installed in accordance with
local Building Regulations.
This is for domestic, indoor use only.
The fitting should be connected to a dedicated lighting
circuit which must be protected by a 5-amp fuse (or a 6-
amp miniature circuit breaker).
Before installing the fitting ensure the mains supply is
switched off, and that the appropriate fuse is removed (or
appropriate circuit breaker is switched off) before
commencing installation. Ensure that measures are taken
to prevent the supply from being inadvertently
reconnected.
If there is a “Minimum Distance” Label, please do not
allow Flammable Materials to rest within that distance
from the lamps.
This product may contain delicate parts –be careful
during handling and maintenance to avoid breakage.
If any modification is made to the fitting it will invalidate
the warranty and may render the product unsafe.
A defective appliance may cause electric shock. Never
switch on a defective appliance. Unplug the appliance
from the mains or switch off at the circuit breaker in the
fuse box before seeking assistance.
This product is IP44 rated, and so no part of the
installation is allowed to be within bathroom Zones 0,1.
Installation is permitted within Zone 2.
This product must be earthed.

BATHROOM ZONES
Zone 0:
The interior of the bathtub or shower basin.
Zone 1:
The area around the bathtub or shower
basin up to a height of 2.25m above the
floor
Zone 2:
The area stretching to 0.6m outside the bath
or shower and above the bath or shower if
over 2.25m

PARTS LIST
TOOLS NEEDED FOR INSTALLATION
SCREW x2
D6 WALL PLUG x2
MIRROR x1
TAPE
MEASURE
SPIRIT
LEVEL
ELECTRIC
DRILL
FLAT HEAD
SCREWDRIVER
HAMMER
8MM
DRILL BIT
PENCIL

PRODUCT OVERVIEW
INSTALLATION
IMPORTANT: Before commencing installation, ensure that there are no
pipes or wires located behind the wall that you will be drilling into.
Ensure that the hanging location has been decided upon and marked
clearly to avoid unwanted damage in the wall due to incorrect
positioning.
Check there the mirror is not damaged prior to installation.
Take care unpacking, do not use a sharp blade to open as this may
damage the mirror and void your warranty.
BACK LIT LED
ILLUMINATION
INFRARED
SENSOR

TECHNICAL SPECIFICATION
Model
BeBa-27580
WxHxD (mm)
500x800x30
Net Weight (Kg)
4.9
Power Cord Length
(cm)
55
Rated Power
33 W
IP Rating
IP44
Input
220 V - 240 V
50 Hz
DISPOSAL
Recycling facilities are now available for all customers at which you can
deposit your old electrical products. Customers will be able to take any old
electrical equipment to participating sites run by their local councils.
Please remember that this equipment will be further handled during the
recycling process, so please be considerate when depositing your
equipment. Please contact the local council for details of your local
household waste recycling centers.
At the time of printing the product contains no substances listed within
Annex XIV of the Reach Regulations (EC) 1907/2006. In accordance with Article 59 of the
same regulation the following substances are contained within the product at permitted
levels: Cadmium.
As a responsible manufacturer the regulations are monitored to ensure continued
compliance. Further information can be provided upon request.