Better Bathrooms Westbury BeBa 27054 User manual

Multi-person assembly
We always recommend using professional
tradespeople to install your product
V1_29.10.2020
BeBa_27054/BeBa_27055/BeBa_27056
Westbury 500mm WC Unit

Congratulations on your purchase
And welcome to our growing gang of savvy shoppers
We're on a mission to bring you extraordinary bathroom products, for less. From modern
to traditional style ceramics, plus the gorgeous fixtures, fittings and furniture to match. So,
you can fall in love with your space every single day.
As one of the UK's largest independent bathroom stores, we've received countless awards;
including the National Business Awards UK, the Digital Entrepreneur Awards and being
placed on The Sunday Times Fast Track 100.
We hope your new product exceeds your highest expectations. However, if you
experience any problems, please:
call our friendly UK call centre on 03303903062 (9am-7pm Monday to Friday, or
10am-4pm Saturday and Sunday), or
send us a message via [email protected]
Important information
Please read these instructions thoroughly and retain for future reference
Please check for pipes and cables before drilling the wall

Y
Z
X
y=325mm
x=502mm
z=818mm
Spirit Level Hammer Pencil Screw Driver
Electric Drill Drill Bit
Tape
Tools required(Tools not provided)
60'
Important information Please read carefully.Keep this information for further reference.
Serious or fatal crushing injuries can occur if furniture is not secured correctly.To prevent
furniture from tipping over it must be permanently fixed to the wall.
Fittings for the wall are not included since different wall materials require different types of fittings .
Use fittings suitable for the walls in your home.For advice on suitable fittings,contact your local dealer.

Gap Adjustment
MIN:2mm
MAX:3mm
Installation

L=224±2MM
H=758±2MM
H
L
01

12×2
Please note - wall fixings are not supplied
These can be purchased from a local DIY store
02
×2

03

04
TOOLS REQUIRED
Tape Measure
INSTALLATION INSTRUCTIONS
Measure the height from the floor to height a Mark these dimensions on to the front
then measure height b and allow 5mm panel of the unit using a pencil
tolerance, then measure width c and allow 5mm
Remove the front panel from the unit It is recommended to seal the cut edge
and cut the hole to allow the waste pipe and bottom edge of the unit, to protect
and flush pipe to pass from the cistern against moisture ingress
Furniture should be maintained using a clean cloth with no harsh abrasive cleaning agents/materials
All furniture should be wiped dry if they become wet
Pencil
Saw

Cleaning
-Clean with a soft cloth & warm soapy water only
-Do not use abrasive cleaning agents
-Dry unit with a cloth after use
The location of the push button can be selected
by the customer, the hole should be drilled then
sealed to prevent moisture penetration