Bishamon LX25SA Operation manual

In this manual, 「Warning」, 「Caution」are defined and specified as below. Notice of Warnings are
very important for safe operations. As these are very Important to protect operators from accidents
resulting in personal injury and death, and damage to property, so make sure to read thoroughly and
understand fully before operation.
Warning
Incorrect operation may result in serious injury or death of the operator.
Caution Incorrect operation may result in injury and damage to the property.
The
Explanation of Terms and Symbols

If it is necessary to go under the raised Lift plaｔform for repair or servicing the Lift,
make sure to remove the load and the scissor mechanism is securely blocked in the
open position. For Model LX300, use Maintenance Pin.
If dirt or obstacles etc. at driving portions are built up (piled up) and obstructing the
driving of the rollers, damage to the Lift unit could result.
Never put hands or feet in or near scissor mechanism and all moving part of the Lift.
SEVERE PERSONAL INJURY could result.
・Platform is supported by hydraulic and lowers slightly as natural lowering.
・DO NOT continue to operate the pump if a squealing noise is heard coming from

Never put hands or feet under the platform when raising or lowering the Lift.
SEVERE PERSONAL INJURY could result.
・If "Up" button and "Down" button are pressed at same time, first pressed takes priority.
・If "Up" and "Down" foot pedal are deressed at same time, "Up" pedal takes priority.
・DO NOT overload the lift table. Always stay within the designated capacity ratings.
・DO NOT concentrate the load at one point on the pallet or platform. Always uniformly
distribute each layer of load over the supporting surface.
・DO NOT use the lift table with an unstable, unbalanced or loosely stacked load.
・DO NOT modify lift table such as enlarging platform, installing big size conveyor etc.
⇒Overturn of lift table and SEVERE PERSONAL INJURY could result.
Make sure to insert Maintenance Pin into hole after platform reached max
height. If inserting at other height, it may damage the Lift.

Ⓐ
Ⓑ
If it is necessary to go under the raised Lift plaｔform for inspection or servicing the Lift, make
sure to remove the load and the scissor mechanism is securely blocked in the open position.
For Model LX300, use Maintenance Pin.

●Lowering Speed is already adjusted and set at factory with specified load. It is not recommended to
change the lowering speed faster which could be danger.
●Changing lowering speed without load could result in faster speed when loaded and could be danger.
●DO NOT adjust Relief Valve for safe use. If nut is loosened, oil could be leaking.

3-21, 4-Chome, Hongo-Cho, Takahama City,
Aichi, Japan 444-1394
Tel. [phone], Fax. [phone]
http//www.bishamon.co.jp/