Fisher-Price Y6591 User manual

Y6591
fisher-price.com
WARNING
To prevent entanglement
injury, never place gym in
a crib or playpen. Never
add strings, ties or other
products to the gym.
Kick & Play
Crawl-Through
Sit & Play

2
PartsConsumer
Information
2 Tubes
(Small and Large)
3 Hanging Toys
Electronic Sun Toy
Mat
2 Bases
• Please keep this instruction sheet
for future reference, as it contains
important information.
• Requires three button cell LR44
batteries (included).
• Adult assembly is required. Tool
required for battery replacement:
Phillips screwdriver (not included).
• Machine wash the mat in cold water
on the gentle cycle. Do not use bleach.
Tumble dry on low heat.
• Surface wash the tubes, toys and
supports with a mild cleaning solution
and damp cloth. Do not use bleach.
Rinse clean to remove residue. Do not
immerse the electronic toy.
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
© Disney
©2013 Mattel. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, except as noted.
PRINTED IN CHINA Y6591pr-0920

3
• Slide the small tube through the
sleeve in the end of the mat.
Kick & Play Setup
Small Tube
Mat Sleeve
• Fit the "T" end of the four straps on
the sides of the mat through the slots
in the bases. Pull up on the mat to be
sure it is secured to the bases.
Mat
Mat
Straps
Straps
Base
Base
Base
Base
1
2
• Fit the ends of the small tube into the
sockets in the bases.
Hint: The tube is designed to fit one way.
If it does not seem to fit, remove it from the
mat sleeve. Then, insert the other end of
the tube into the same opening in the
mat sleeve.
3
• Fit the ends of the large tube into the
base sockets.
Hint: The tube is designed to fit one
way. If it does not seem to fit, turn it
around and try again.
4
Sockets
Large Tube

4
• Fit the "T" end of the four straps on
the sides of the mat through the slots
in the bases. Pull up on the mat to be
sure it is secured to the bases.
Mat Straps
Bases
Sit & Play and
Crawl-Through Setup
Kick & Play Setup
• Fit the link on the electronic sun toy
to the strap on the mat for kick and
play fun!
• Fit the link on each toy to the straps
on the large tube.
5
1

5
• Fit the ends of the small tube into the
sockets in the bases.
Hint: The tube is designed to fit one
way. If it does not seem to fit, turn it
around and try again.
Small Tube
2
Sit & Play and Crawl-Through Setup
• Fit the ends of the large tube into the
sockets in the bases.
Hint: The tube is designed to fit one
way. If it does not seem to fit, turn it
around and try again.
3
Large Tube

6
• Fit the link on each hanging toy to the
straps on the tubes.
4
Music, Lights
& Giggles!
Sit & Play and
Crawl-Through Setup
• Slide the power switch on the
electronic toy to ON or OFF .
Power Switch
Bat at sun toy for
music & giggles!

7
Battery Replacement
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver and remove the door.
• Remove the exhausted batteries and
dispose properly.
• Insert three new button cell LR44
alkaline batteries.
• Replace the battery compartment door
and tighten the screws. Do not
over-tighten.
• If this toy begins to operate erratically,
you may need to reset the electronics.
Slide the power switch off and back on.
• When sounds or light become faint or
stop, it's time for an adult to change
the batteries.
• Protect the environment
by not disposing of this
product with household waste
(2002/96/EC). Check your
local authority for recycling
advice and facilities.
1,5V x 3
LR44 or equivalent
Battery Safety Information
In exceptional circumstances,
batteries may leak fluids that can cause
a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.

8
FCC Statement (United States Only)
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could
void the user’s authority to operate
the equipment.
ICES-003
This Class B digital apparatus complies
with Canadian ICES-003. Operation is
subject to the following two conditions:
(1) this device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe
B est conforme à la norme NMB-003
du Canada. L’utilisation de ce dispositif
est autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Consumer Information