Body Craft F530 User manual

Model No. F530
MB1326
Recreation Supply Inc.
BODYCRAFT is a division of Recreation Supply
7699 Green Meadows Drive
Lewis Center, OH 43035
Serial Number Location
Record your Serial number
and purchase date here:
S/N __________________
PURCH.DATE:_________
DEALER:______________
______________________
______________________
S E R I A L
1 2 3 4 5 6 7 8
46" 3- Tier Dumbbell / Accessory Rack
OWNER'S MANUAL
Located under the Top Tier

1
.
Congratulations and Thank You!
Important Safety Notes
QUESTIONS?
Thank you for selecting the Bodycraft 46" 3-Tier Dumbbell Rack.
For your safety and benefit, read this manual and the accompanying literature
before using the Bodycraft Dumbbell Rack. Keep this manual for future
reference. If you have additional questions, please call your local Bodycraft
dealer or our customer service department at 800-990-5556 Monday
through Friday, 9 am until 5 pm Eastern Standard Time.
There is a risk assumed by individuals who use this type of equipment.
Before beginning this or any other exercise program consult your physician.
This is especially important for individuals over the age of 35 or persons with
preexisting health problems. Recreation Supply, Inc. assumes no
responsibility for personal injury or property damage sustained by or through
use of this product.
1. This product must be assembled on a flat, level surface to assure its proper function.
2. Clean pads and the frame on a regular basis. We recommend warm, soapy water.
Do not use harsh or abrasive chemicals.
3. Inspect and tighten all parts before every use. Replace any worn
parts immediately. Failure to do so may result in serious injury.
4. Keep children away from the BODYCRAFT Dumbbell Rack at all times.
5. If you are unsure about the proper use of the BODYCRAFT Dumbbell Rack, please
call your local BODYCRAFT dealer or our customer service department.
As a quality exercise equipment supplier we are committed to your complete
satisfaction. If you have questions, or find missing or damaged parts, we will
guarantee your complete satisfaction through our authorized dealer service
centers or our home office customer service department. Please call your local
dealer for assistance or BODYCRAFT at 800-990-5556 (9 AM - 5 PM) EST. Our
trained technicians will provide immediate assistance to you, free of charge.

Assemble Parts List
NOTE: IF A PART IS MISSING, IT LIKELY HAS BEEN PRE-INSTALLED FOR
QUALITY CONTROL PURPOSES. PLEASE PROCEED WITH ASSEMBLY.
(1) MAIN FRAME X 2pcs
(2T) TOP DUMBBELL TIER X 1pcs
(3) STEEL BACKING
PLATE X 6pcs
(5) RUBBER FOOT
X 4pcs
(6) 50 X 100mm
END CAP
X 2pcs
NO. DESCRIPTION QTY.
12
24
12
1/2" X 3-1/8" HEX BOLT
1/2" WASHER
1/2" NYLON NUT
7
8
9
(7) (8) (9)
2
*Parts images are not to scale.
(2L) LOW DUMBBELL TIER X 2pcs
i.e. 2-1/4" Hex Bolt
01/4 1/2 3/4 1" 1/4 1/2 3/4 2" 1/4 1/2 3/4 3" 1/4
When measuring bolt lengths, only measure the shank.
Additional Hole for
Angle Adjustment

0
13.3
PLEASE CHOOSE BETWEEN OPTION A OR B.
This Dumbbell Rack has been designed with an adjustable top tier #2T, it can be assembled
in the flat position (OPTION A) or at an angle (OPTION B).
A. If you wish to use the Top Tier for items such as Kettlebells, Lat Bars or other
Accessories, it is recommended that you assemble it in the flat position.
B. For Dumbbells, the angled position is recommended, but either position will work.
If you have a mixture of Dumbbells and Accessories, use Option A.
Adjustable Top Tier Overview
3
A
B

(NOTE: Two Racks can be joined to make a longer rack. If you have
purchased a second rack wish to connect them, please refer to the next
page for additional information. Please recycle unused components.
1. Using a Rubber Mallet or similar tool, install the #6 CAPS into the top
of BOTH of the #1 MAIN FRAMES as shown in Fig. 1. IMPORTANT: If
the caps are cold. please let them acclimate to room temperature
before installation or they may be damaged during installation.
2. By hand, install the four #5 RUBBER FEET onto both of the #1 MAIN
FRAMES as shown in Fig. 1.
3. Start by LOOSELY installing one of the #2L LOW DUMBBELL
TIERS in the bottom set of holes of both of the #1 MAIN FRAMES.
IMPORTANT: Please take care to install the #3 BACKING PLATES
onto the outside of each of the #1 MAIN FRAMES.
4. LOOSELY install the second #2L LOW DUMBBELL TIER in
the middle set of holes as shown in Fig 2.
5. LOOSELY install the #2T TOP DUMBBELL TIER. Please refer to
page 3 for the installation choices. In the drawing below we are
installing it at an angle. For flat use the rear upper hole.

TIGHTEN ALL BOLTS AT THIS TIME!
Assembly is Complete!
1
6
5
5
FIG. 1
FIG. 2
1
2L
2L
2T
3
3
7
8
7
8
7
8
7
8
7
8
8
9
8
9
8
89
9
8
9
8
9
8
9
7
8
3
3
3
3
7
78
8
7
78
8
7
78
8
1
89
89
ASSEMBLY
4

When joining 2 rack together, remove the parts listed at the bottom from the assembly
area The #1 MAIN FRAME used in the Center position will not require the #3 Backing
Plates.
Remaining Components to save or recycle
Connecting 2 Racks into 1
Discarded Parts, please recycle
5
(7) 1/2" x 3-1/8"
Bolts 6pcs
(5) Rubber
Foot 2pcs
(8) 1/2"
Washers
12pcs
(6) 50 x 100mm
End Cap 1pcs
(8) Steel
Backing plate
6pcs
(9) 1/2" Nuts
6pcs
(1) Main Frame
2pcs
7
8
7
7
8
7
7
8
7
8
9
8
9
8
9
8
9
3
7
8
7
8

1
2L
2L
2T
4
6
6
3
3
7
8
7
8
7
8
7
8
7
8
8
9
8
9
8
89
9
8
9
8
9
8
9
7
8
3
3
3
3
7
78
8
7
78
8
7
78
8
5
5
55
1
EXPLODED
6
89
89

1
2T
2L
3
4
5
6
7
8
9
1
1
2
6
1
4
2
12
24
12
MAIN FRAME
TOP DUMBBELL TIER
LOW DUMBBELL TIER
STEEL BACKING PLATE
NON-SLIP PVC LINER
RUBBER FOOT
50 X 100mm END CAP
1/2" X 3-1/8" HEX BOLT
1/2" WASHER
1/2" NYLON NUT
NO. DESCRIPTION QTY.
7
(7)
(1)
(3) (5) (6)
(2T)
(4) (8) (9)
COMPLETE PARTS CHART
*Parts images are not to scale.
(2L)
Please take the following steps before using the Dumbbell Rack:
1. Be certain all bolts are tightened securely. Check and tighten all bolts before every use.
2. If unsure about the proper use of the Dumbbell Rack call your local dealer or our customer
service department at 800-990-5556.
3. Keep children away from the Dumbbell Rack.
4. Enjoy many years of Fit Lifestyle!
Please call us, or email us to let us know your thoughts! We love, and strive to provide the
world's best fitness equipment!
www.bodycraft.com or [e-mail]