BOMBAY 1851148 User manual

1851148
Canterbury Console
Page 1 of 3 R2-4-18-00
Parts and Hardware List
A. Top Assembly 1 pc
B. Legs 4 pcs
C. Allen Head Bolts 8 pcs
D. Lock Washers 8 pcs
E. Flat Washers 8 pcs
F. Allen Head Wrench 1 pc
G. Finial 1 pc
H. Key 2 pcs
∗ Please make sure that you have all the parts and hardware indicated above before you begin assembly
of this item.
∗ Use the hardware illustrations to determine correct piece and size.
∗ This item should be assembled on a soft surface to prevent scratching the finish during assembly.
∗ This item may require periodic tightening.
Hardware Illustrations

1851148
Canterbury Console
Page 2 of 3 R2-4-18-00
Pull Out Drawers
Parts required
A. Top Assembly 1 pc
1. Pull Out Drawers Place the Top Assembly (A) up side down on the floor. Remove the wood dowels from the
slide rails and pull out the drawers from Top Assembly (A). See Illustration # 1.
A
A
Illustration # 1
Attach Legs to Top Assembly

1851148
Canterbury Console
Page 3 of 3 R2-4-18-00
Parts required
A. Top Assembly 1 pc E. Flat Washers 8 pcs
B. Legs 4 pcs F. Allen Head Wrench 1 pc
C. Allen Head Bolts 8 pcs G. Finial 1 pc
D. Lock Washers 8 pcs
2. Attach Legs (B) Align the pre-threaded holes in the Legs (B) with the pre-drilled holes in the corner blocks
between the aprons and secure in place with the Allen Head Bolts (C), Lock Washers (D), Flat Washers (E)
using the Allen Head Wrench (F).
3. Attach Finial (G) Insert the Finial (G) into the pre-threaded hole in the front apron and tighten in a clockwise
direction.
4. Install Drawers Carefully turn the assembled console upright. Slide the drawers into the Top Assembly (A)
and insert the wood dowels into the pre-drilled holes in the slide rails. These will function as a drawer stop.
See Illustration # 2.
B
B
G
F
AB
C
D
E
B
G
A
Illustration # 2