baby&child SERAPHINE QUEEN BED User manual

S E R A P H I N E Q U E E N B E D
IMPORTANT
We recommend assembly by two or more people.
Page 1 of 3
D E S C R I P T I O N
PART LIST
WARNING: ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL PARTS,
SHARP POINTS AND EDGES
HARDWARE LIST
A HEADBOARD
B SIDE RAILS
C FOOT BOARD
D SET OF BED SLATS
E SUPPORT SLAT
F LEG
Customer Service - If you are missing parts or have any question about this product please
contact us at 1-800-762-1751
NO.
1
2
3
4HEX NUT
THREADED ROD
CURVED WASHER
LOCK WASHER
QTY.
8 PCS
8 PCS
8 PCS
8 PCS
5WRENCH 1 PC

A / C
FIGURE 02
ASSEMBLY INSTRUCTIONS
Thank you for choosing this quality product.
Be sure to check all packaging materials
carefully for small parts that may have
become loose during shipment and place all
parts on a non-abrasive surface.
The bed is composed of several components:
The headboard, side rails, foot board, bed
slats, support slat and leg. Determine the
intended location and ensure there is enough
space to work with and fully read these
instructions before physically doing the entire
assembly.
STEP #1:
Gently lay down the headboard (A) and
footboard (C) on a plain and non-abrasive
surface.
Note: on the bottom of both headboard (A)
and footboard (C) are holes with
pre-installed nuts that correspond to the
threaded rods pre-installed in the leg (E).
STEP #1.2
Align and insert the threaded rod of the leg
(E) into the hole and turn clockwise to
tighten as illustrated in FIGURE 01.
STEP #3:
Place the headboard (A) upright in the
position you wish the bed to be in when fully
assembled. The headboard bed fast hardware
should be facing the inside, toward the
mattress. Secure the threaded rods (1) to the
fixed nuts in the headboard (A) by simply
turning manually. Raise the side rail (B) up
and place the rods (1) to align with the bore
holes on the end of the side rails (B). Put the
side rails (B) up against the headboard (A) so
the threaded rods go through the bore holes.
Insert curved washers (2) and lock washers
(3), place hex nuts (4) on threaded rods (1)
and tighten hex nuts (4) with wrench (5), as
illustrated in FIGURE 02.
FIGURE 01
FIGURE 02
Page 2 of 3

FIGURE 03
FIGURE 04
STEP #4:
Repeat the above procedure with the
other side rail (B) to attach it to the
headboard (A), and then repeat to
connect side rails (B) to the footboard
(C).
STEP #5:
On inside face of both headboard (A)
and footboard (C) are pre-installed
wooden brackets for the support slat
(E). Set the support slat (E) on the
wooden bracket, as illustrated in
FIGURE 03.
STEP #6:
On inside surface of both side rails (B)
are cavities designed to hold the
individual bed slats (E). Set individual
bed slats (E) on both sides of the side
rails (B) as illustrated in FIGURE 04.
Page 3 of 3
Thank you for your purchase
www.rhbabyandchild.com