Bosch D5370-USB User manual

RPS Security Block
D5370‑USB
en Installation Manual

RPS Security Block Table of contents | en 3
Bosch Security Systems, Inc. Installation Manual 2015.03 | 01 | F.01U.310.788
Table of contents
1System overview 4
1.1 Typical RPS Network 4
1.2 General information 4
1.3 Supported platforms 4
2Installation 6

4en | System overview RPS Security Block
2015.03 | 01 | F.01U.310.788 Installation Manual Bosch Security Systems, Inc.
1 System overview
This section provides an example of a typical network configuration and general information to
assist with your Sentinel Protection Server installation.
1.1 Typical RPS Network
RPS (Remote Programming Software) takes advantage of the Sentinel Protection Server, a
feature available with the D5370 RPS Security Block dongles. This feature allows all RPS
workstations on a LAN to communicate with a control panel as long as one or more of the
workstations or Windows file servers on the LAN has an installed RPS Security Block.
1
2
3
4
5
Callout - Description
1 - D5370-USB RPS Security Block (USB port)
2 - RPS workstation with Sentinel Protection Server and RPS Security Block installed
3 - Network drive with RPS database
4 - RPS workstation using the networked RPS Security Block
5 - Common subnet networking equipment
Install the security key on any machine attached to the network, server or client.
1.2 General information
– When you run the setup program, it automatically updates your version of the Windows
Installer, if necessary. It does not prompt before doing this.
– Administrator privileges are required for installing and setting it up on any Windows OS.
1.3 Supported platforms
– Windows Server 2003 (32-bit and 64-bit)

RPS Security Block System overview | en 5
Bosch Security Systems, Inc. Installation Manual 2015.03 | 01 | F.01U.310.788
– Windows Server 2008 (32-bit and 64-bit)
– Windows Server 2008 R2 (64-bit)
– Windows 7 (32-bit and 64-bit), Windows 8 (32-bit and 64-bit), Windows Server 2012 (64-
bit)
– Windows 8.1 (32-bit and 64-bit)

6en | Installation RPS Security Block
2015.03 | 01 | F.01U.310.788 Installation Manual Bosch Security Systems, Inc.
2 Installation
Install on every workstation on the subnet where you might attach the Security Block. You do
not need a Security Block on more than one workstation on your network, but you might
choose to install additional Security Blocks to prevent a loss of communications in the event
of a workstation failure.
If necessary, Bosch has included the latest Sentinel Drivers in the folder \D5370-D5371
Dongle Hardware Key Drivers.

Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, NY 14450
USA
www.boschsecurity.com
© Bosch Security Systems, Inc., 2018
Bosch Sicherheitssysteme GmbH
Robert-Bosch-Ring 5
85630 Grasbrunn
Germany