Bose PROFLIGHT User manual

Please read and keep all safety and use instructions.
PROFLIGHT
AVIATION HEADSET
All manuals and user guides at all-guides.com
all-guides.com

Insert the AA batteries (2)
into the control module.
A. Place the headset on your head.
B. Adjust the headband so the side
pads rest above your ears.
On the control module, press the Power button I.
NOTE: For Dual plug only. For 5-pin XLR, 6-pin
Lemo, and 7-pin XLR, the headset powers
on automatically when connected to aircraft
power.
Insert the aircraft connector into the
aircraft control panel.
A. Locate the left Tand right Uicons
on the headband to orient the
headset properly.
B. Rotate the side pads into position.
5-pin XLR
6-pin Lemo
7-pin XLR
Microphone
Intercom/audio
Dual plug
a ba b
c
e f
g
All manuals and user guides at all-guides.com

On the control module, press the Power button I.
NOTE: For Dual plug only. For 5-pin XLR, 6-pin
Lemo, and 7-pin XLR, the headset powers
on automatically when connected to aircraft
power.
Connect your mobile device.
Power button
A. Insert the earbuds.
B. Tilt the earbuds back, and tuck the
wing under the ear ridge until the fit
is secure.
NOTE: Medium tips are attached. Refer
to the owner’s guide for more
information on proper fit.
Adjust the microphone so it is
0.5" (12.7 mm) from your lips
and the white surface is facing
your mouth.
bb
c d
f
g h
All manuals and user guides at all-guides.com

©2018 Bose Corporation, The Mountain,
Framingham, MA 01701-9168 USA
AM802340-0040 Rev. 00
Acoustic Noise Cancelling™ functions
High Maximum quiet and noise cancellation across the entire spectrum.
Best signal-to-noise ratio for radio and intercom communications.
Medium Optimized mode for quieter aircraft.
Low Best for interpersonal communication outside of the intercom.
NOTE: To set noise cancellation to Low on a single earbud, set the Tap
Control switch to On, and firmly double-tap the earbud.
Bluetooth® audio priority
Mute When an intercom signal is detected, mobile device audio is
temporarily muted until intercom audio ceases.
Mix When an intercom signal is detected, mobile device audio is mixed
with intercom audio.
O Only intercom audio is active. Bluetooth functionality is disabled.
To enhance your headset experience, download the Bose® Connect app.
w
global.Bose.com/Support/ProFlight
m X o s W
Operation switches
Reserved Reserved for future use.
Auto on Power on automatically when connected
to aircraft power.
Aircraft audio Set sensitivity/volume of intercom audio.
Intercom Process audio as mono or stereo.
Auto o Power o automatically after 3 to 45
minutes of inactivity.
Tap Control Enable Tap Control interaction.
NOTE: Some operation switches are not available on
all models.
All manuals and user guides at all-guides.com