Boyo VTB100TJ User manual

Rearview Camera
with dynamic parking line
VTB100TJ
Product Manual

I. Specifications
Sensor
1/3” CMOS PC3089
Effective Pixel
762（H）X504（V）
Video Signal
PAL60HZ/ NTSC60HZ
Dynamic Guidance Trajectory
Embedded
Scanning system
2:1 interface
AGC
Auto
BLC
Auto
Resolution
600 TV lines
S/N Ratio
More Than 48dB
Current Consumption
No more 180mA
Power Supply
DC 12V
Operating temperature
-20℃~70℃
Storage temperature
-30℃~80℃
View Angle
170°
Water-proof
IP67
Minimum Illumination
0.5Lux/ F1.2 (0Lux with LED)
Application
universal

Ⅱ. Installation Instructions
1) Find a suitable location to mount the camera so its view is
unobstructed.
2) Connect the RED wire to either a +12 volt accessory wire (if you want
the camera to come on with the ignition) or to the +12 volt reverse wire
(if you want the camera to come on only when the vehicle is in reverse).
3) Connect the BLACK wire to ground.
4) Run the video output of the camera to the video input/reverse camera
input of the video screen.
5) Once all connections have been made and before mounting the
camera, make sure the camera comes on and you have a good view of
the area.
6) Since the camera is verified working, mount the camera down with
two screws.

Ш. Installation NOTES
Caution: The smart rear view camera must be mounted at certain
angle (30°~40°) . It must not be mounted horizontally straight. Otherwise
the sensitivity and accuracy will be affected accordingly.
Please do not modify the structure or cut off the wires without
permission.