Bradley S19-465 User manual

P.O. Box 309, Menomonee Falls, WI USA 53052-0309
PHONE 1-800-BRADLEY FAX [phone]
bradleycorp.com
Installation
215-1168 Rev. L; ECN 08-507
© 2008 Bradley Corporation
Page 1 of 3 4/30/08
S19-465
Deck-Mounted Hand-Held Drench
Hose
Table of Contents
Pre-Installation Information . . . . . . . . . . . . . . . . . . . . . . 2
Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . 2
Assembly of Components . . . . . . . . . . . . . . . . . . . . . . . 3
Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

2
S19-465 Installation
4/30/08 Bradley Corporation • 215-1168 Rev. L; ECN 08-507
IMPORTANT
Read this installation manual completely to ensure proper installation, then file it
with the owner or maintenance department. Compliance and conformity to drain
requirements and other local codes and ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before
discarding any packaging material. If any parts are missing, do not begin installation
until you obtain the missing parts.
Flush the water supply lines before beginning installation and after installation is
complete. Test the unit for leaks and adequate water flow. Main water supply to the
eyewash should be “ON” at all times. Provisions shall be made to prevent unauthorized
shutoff.
The ANSI Z358.1 standard requires an uninterruptible supply of flushing fluid at a
minimum 30 PSI (0.21 MPa) flowing pressure. Flushing fluid should be tepid per ANSI
Z358.1.
The inspection and testing results of this equipment should be recorded weekly
to verify proper operation. This equipment should be inspected annually to ensure
compliance with ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should be
trained regarding the placement and proper operation of emergency equipment per
ANSI Z358.1.
For questions regarding the operation or installation of this product, visit www.
bradleycorp.com or call 1-800-BRADLEY.
Product warranties and service parts information may also be found under ”Products”
on our web site at www.bradleycorp.com.
Installation
THIS
SIDE
UP
Packing List
•
•
•
•
P.O.Box309,MenomoneeFalls,WI53051
R
TESTTHISUNITEACHWEEK
Test-operatevalve(s) each week and sign below.
Reportany malfunctions immediately.
Ventil(e)wöchentlich im Testbetriebprüfen, bestätigt
durchUnterschrift. Jegliche Störung sofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESESGERÄT1STWÖCHENTLICHZUPRÜFEN.
ESSAIHEBDOMADAIRE
Testle fonctionnement des valves chaque semaine et
signeen bas. S'il y à quelque chose qui ne va pas fait
unrapport immédiatement.
P.O.BOX309, MENOMONEE FALLS,WI 53052-0309 USA
TEL:1-800-BRADLEY FAX: [phone])
http://www.bradleycorp.com
114-051
Installation
Supplies Required:
• 1/2" NPT water supply
• Backflow prevention device as required by UPC, IPC and/or local plumbing codes
Step 1: Prepare deck for installation
1. Rough-in 1/2" NPT supply piping from wall where drench hose is desired (piping supplied by installer).
2. Select desired location in deck for drench hose and drill a 1-5/16" (34mm) diameter hole.
3. Install the drain plug using the washers and locknut provided (refer to page 3).
Step 2: Install Drench Hose
1. Install the drench hose components as shown on page 3.
• Apply pipe sealant (supplied by installer) to all male-threaded pipe joints.
Step 3: Connect water supply
1. Connect the end of the drench hose to the 1/2" NPT water supply piping (supplied by installer).
2. Open the water supply lines and test for leaks and adequate water flow.

3
Installation S19-465
Bradley Corporation • 215-1168 Rev. L; ECN 08-507 4/30/08
Assembly of Components and Parts List
10-3/4"
(273mm)
2-1/4" (57mm)
minimum distance
from wall
1 S27-265 1 Valve Assembly
1.1 269-661 1 Valve Handle only
2 113-544A 1 Closed Nipple
3 169-1006 1 1/4 45 Elbow
4 S05-158 1 EFW Assembly
5 S53-063 1 Dust Cover
6 S89-002 1 3/8" Yellow Tube
7 153-380 1 Adapter
8 S29-092 1 Drain Flange Assembly
9 125-001CE 1 Washer, Rubber
10 169-875 1 Washer
11 169-059 1 Reducing Coupling
12 204-421 1 Emergency Inspection Tag
Item Part No. Qty Description Item Part No. Qty Description
3
2
8
10
7
5
9
6
11
P.O. Box 309, Menomonee Falls, WI 53051
R
TEST THISUNIT EACH WEEK
Test-operate valve(s) each week and sign below.
Report any malfunctionsimmediately.
Ventil(e) wöchentlich im Testbetrieb prüfen, bestätigt
durch Unterschrift. Jegliche Störungsofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESESGERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
ESSAI HEBDOMADAIRE
Test le fonctionnement desvalveschaque semaine et
signe en bas. S'il y à quelque chose qui ne va pasfait
un rapport immédiatement.
12
4
1.1
1