Bristan Manhattan MH SNK C User manual

Manhattan
Monobloc Kitchen Mixer
AFTERCARE INSTRUCTIONS
Your fitting has a high quality finish and should be treated with care
to preserve the visible surfaces. All surface finishes will wear if not
cleaned correctly, the only safe way to clean your mixer is to wipe
with a soft damp cloth. Stains can be removed using washing up
liquid. All bath cleaning powders and liquids will damage the surface
of your fitting even the non-scratch cleaners.
GUARANTEE
All products are manufactured to the highest standards and a 5 year
guarantee covers any defect in manufacture. As gold and special
effect finishes are softer than chromium plate, special care must be
taken when cleaning, a 3 year guarantee covers these finishes.
NOTE: The 5 year guarantee on the valves is invalidated if
damaged by any water born debris.
In the interests of continuous product development we reserve the
right to alter specification as necessary.
PRODUCT CODE: MH SNK C/MOC/BGE/WHT
TELEPHONE HELP LINE: 0844 701 6273
Bristan Group Ltd
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
A Masco Company
Web Site: www.bristan.com
Telephone: [phone]
Facsimile: 0844 701 6275
Email: [email protected]
(FI MH SNK) (Rev D3)
Fitting
Instructions
Please keep these instructions for future reference
and for the ordering of spare parts.

METAL ’C’ PLATE
RUBBER ’C’ PLATE
SINK
FULL RUBBER WASHER
WATER PRESSURE
This mixer is suitable for use at all supply pressures.
If the fitting is installed at low pressure (tank fed), then the minimum
height from the outlet of the nozzle to the underside of the cold tank
should be 2 metres to ensure adequate performance.
This mixer should be installed in compliance with Water
Regulations. For further details contact your Local Water Authority.
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging installation
2. Fit the mixer body to the sink using the ’C’ plate fixing kit. The full
rubber washer goes between the fitting and the sink. The optional
nylon ring can be used between the underside of the sink and the
rubber washer if need be. The ’C’ shaped rubber and metal washers
also go on the underside of the sink.
3. Fit the flexi tails to the fitting and connect the hot and cold
supplies.
4. Fully open both valves, letting them run for a few minutes to flush
the system.
5. Check all joints and connections for leaks.
6. See over the page for aftercare instructions.
MAINTENANCE
All valve types: - If the fitting begins to drip
1. Turn off the water supply.
2. Remove fitting head and valve.
3. Carefully clean seating and rubber washer.
4. Replace valve and turn on the water supply.
5. Contact our helpline if problem persists.
Please Note: In the unlikely event you find a part missing please
contact our Customer Service Help line on or email0844 701 6273
[email protected] for immediate dispatch of part.
Operating Pressures: Min 0.2 bar, Max 7.0 bar.