Bristan Quest QST BF C User manual

AFTERCARE INSTRUCTIONS
Your fitting has a high quality finish and should be treated with care
to preserve the visible surfaces. All surface finishes will wear if not
cleaned correctly, the only safe way to clean your mixer is to wipe
with a soft damp cloth. Stains can be removed using washing up
liquid. All bath cleaning powders and liquids will damage the surface
of your fitting, even non-scratch cleaners.
GUARANTEE
All products are manufactured to the highest standards and a 5 year
guarantee covers any defect in manufacture.
NOTE: The 5 year guarantee on the valves is invalidated if damaged
by any waterborne debris.
In the interests of continuous product development we reserve the
right to alter specification as necessary.
PRODUCT CODE: QST BF C
TELEPHONE HELP LINE: 0844 701 6273
Bristan Group Limited
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
Web Site: www.bristan.com
Telephone: [phone]
Facsimile: 0844 701 6275
Email: [e-mail]
(FI QST BF) (Rev. D3)
Quest Bath Filler
Fitting Instructions
& Contents List
Please keep these instructions for future reference
and for the ordering of spare parts.

2
3
c
b
a
1
d
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for
optimum, both the hot and cold supplies should be reasonably
balanced.
If the fitting is installed at low pressure (tank fed), then the minimum
height from the outlet of the nozzle to the underside of the cold tank
should be 2 metres to ensure adequate performance.
This mixer should be installed in compliance with Water Regulations.
For further details contact your Local Water Authority.
CONTENTS
1. Mixer Body (x1)
2. Back nut (x2)
a. Valve (x2)
b. Spline adaptor (x2)
c. Screw (x2)
d. Handle (x2)
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Install the mixer body (1) to the bath using the back nuts (2)
provided.
3. Connect the hot and cold water supplies.
4. Turn on the water supplies. Turn on both hot and cold taps for a
few minutes letting the water flow, to check all joints and connections
for leaks.
5. See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
1. Turn off the water supply.
2. Remove handle (d) and then remove screw (c) by pulling from
valve (a).
3. Also remove spline adaptor (b) to avoid damaging it.
4. Using a suitable spanner, remove valve. Once removed, carefully
clean seating, rubber washer and ceramic disc.
5. Replace all of the above then turn on the water supply.
6. If problem persists contact our helpline quoting the product code.
PLEASE NOTE:
In the unlikely event you find a part missing please contact our
[e-mail] for immediate dispatch of part.
2