Bristan Rio RO 1/2 C User manual

AFTERCARE INSTRUCTIONS
Your fitting has a high quality finish and should be treated with care
to preserve the visible surfaces. All surface finishes will wear if not
cleaned correctly, the only safe way to clean your tap is to wipe with
a soft damp cloth. Stains can be removed using washing up liquid.
All bath cleaning powders and liquids will damage the surface of
your fitting even the non-scratchcleaners.
GUARANTEE
All products are manufactured to the highest standards and a 5 year
guarantee covers anydefect in manufacture.
NOTE: -the 5 year guarantee on the valves is invalidated if
damaged by any waterborne debris.
In the interests of continuous product development Bristan reserve
the right to alter specification as necessary
PRODUCT CODE: RO ½ C / RO ¾ C
TELEPHONE HELP LINE :0844 701 6273
Bristan Group Ltd
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
A Masco Company
Web Site: www.bristan.com
Telephone: [phone]
Facsimile: 0844 701 6275
Email: [email protected]
(FI RO TAP)(Rev. D3)(H)
Rio Basin & Bath Taps
Fitting Instructions
& Contents List
Please keep these instructions for future reference and request
ofreplacementparts.
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk

Washer & seat
Rubber washer valve
e
f
b
d
c
a
Fig.1
4
5
1
23
Fig.1
WATER PRESSURE
These taps are suitable for use at all supply pressures.
If the taps are installed at low pressure (tank fed), then the minimum
height from the outlet of the nozzle to the underside of the cold tank
should be 2 metres to ensure adequate performance.
These taps should be installed in compliance with Water
Regulations. For further details contact your Local Water Authority.
Please Note: -
In the unlikely event you find a part missing please contact our
Customer Service Help line on 0844 701 6273 or e-mail
[email protected]for immediate dispatch of part.
INSTALLATION
1. Identify all components and check for completeness,
particularly before arrangingfitting.
2. Install the taps (1) into the basin or bath, using the washers (4)
above and backnuts (5) below basin or bath. The plinth (2) and
O-ring (3) go between the taps and the bath or basin.
3. Connect the hot and cold water supplies.
4. Turn on the water supplies. Open both taps letting the water
flow for a few minutes to check all joints and connections for
leaks.
5. See over the page for aftercare instructions.
6. To fit the Aerator unscrew the flow straightener for the end of
the spout and screw in the replacement aerator.
Note:-* The aerator is only supplied with the basin taps and should
only be fitted to taps on pressurised systems.
MAINTENANCE
If the fitting begins to drip:
1. Turn off the water supply.
2. Unscrew cap (a), remove indice (b) loosen screw (c) and remove
handle (d).
3. Unscrew shroud (e) and removeceramic disc valve (f).
3. Carefully clean seating and rubber washer.
4. Replace components and turn on the water supply.
5. Contact our helpline if problem persists.
CONTENTS
1. Body (x2)
2. Plinth (x2)
3. Rubber O-Ring (x2)
4. Washer (x2)
5. Backnut (x2)
6. Aerator*(x2)
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk