Brodit 511484 User manual

3 February, 2021, www.brodit.com, © 2021 Brodit AB
Product 511484
511484 Passive holder with tilt swivel Adjustable holder. Fits for devices with and without skin with the
following dimensions: Width: 75-89 mm, Thickness: 12-16 mm.
Keep your phone in a passive holder on the road and you will always have it within easy sight and reach. Safe,
comfortable and convenient!
The adjustable holder fits for devices with and without skin with the following dimensions: Width: 75-89 mm,
Thickness: 12-16 mm. Adjustable holders come in various sizes. Measure your device and compare with the
holder specifications in order to make sure you have chosen the correct product (if you are using a skin: measure
the device with the skin in place).
Before using the holder you set the holder's width so it suits your device, then your phone is held firmly in place in
an upright position for maximum cellular reception. The holder has a neat and discreet design which blends well
with the vehicle's interior. You can connect e.g. a portable handsfree or a charging cable to the device when it is
in place in the holder.
The holder is made of black ABS plastic. It is easy to put the device into the holder, and just as easy to take it
with you when leaving the vehicle. The holder is equipped with a tilt swivel so you can adjust the angle of your
device in order to avoid light reflection on the screen. You can tilt the holder 22° in each direction. Attach onto
ProClip Mounting Platform.
EAN: 7320285114845

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. To adjust the holder for your device: Loosen the screws on the front side of the holder, so the sides of the
holders can be adjusted. Place the device in the holder and press the sides together so the device is firmly in
place. Tighten the screws on the front side of the holder.
2.To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching
plate on the back.
3. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed
screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns
on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same
time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a
bit so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.