Brodit 810827 User manual

25 August, 2021, www.brodit.com, © 2021 Brodit AB
Product 810827
810827 Headrest mount with monitor mount Angled. For multimedia-monitors with a vertical slot in back.
Headrest mount
For installation of multimedia screens in vehicles. Fits screens with a vertical slot on the back side. The screen
mount is placed onto a front seat’s head rest. It comes with a tilt swivel so the screen can be adjusted in order to
avoid reflection. It’s easy to take the screen with you when leaving the vehicle. The installation is quick and will
not damage the interior of the vehicle.
The head rest screen mount fits a number of vehicles, some of them are listed here. Are you missing a model?
Measure the head rest in you vehicle, if its minimum inner size is 123 mm and maximum outer size is 183 mm,
this product will fit your vehicle.
EAN: 7320288108278
Item no 810827 fits:
BMW 5-series F10, F11 10-17 (For all countries)
BMW 5-series F10, F11 10-17 (For all countries)
BMW 5-series GT F07 10-17 (For all countries)
BMW 5-series GT F07 10-17 (For all countries)
BMW 7-series F01, F02 09-15 (For all countries)
BMW 7-series F01, F02 09-15 (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Attention! Read all instructions before attaching the head rest mount.
1. Remove the head rest. Place the head rest mount onto the head rest bars. The face plate shall be on the back
side of the head rest. Put back the head rest.
If the head rest can not be removed, remove the two screws in the frontside of the head rest mount. Place one
part of the head rest mount on each side of the head rest. The face plate is to be on the back side of the head
rest. Put back the screws.
2. Tighten the screws on the frontside of the head rest mount, using the enclosed tool. Screw until the head rest
mount is properly in place.
3. Pull up the head rest and the head rest mount. Press the face plate towards the head rest and tighten the
screw in the buttom of the head rest mount. Adjust the head rest into desired position.
4. Adjust the face plate into desired position. Tighten the screw in the face plate. The head rest mount is in place.