Brodit ProClip 854344 User manual

19 February, 2014, www.brodit.com, © 2014 Brodit AB
Product 854344
854344 ProClip
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288543444
Item no 854344 fits:
Peugeot 3008 09-14 (For Europe)
1(2)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the
enclosed gap opener into the gap between the dashboard and the frame surrounding the air vent, to widen the
gap. Peel off the adhesive tape covers on the ProClip.
2. Press the angled edge on the lower part of the ProClip into the gap next to the gap opener. Pull out the gap
opener.
3. Press the gap opener into the gap between the frame surrounding the air vent and the dashboard. In the same
time: Press the upper part of the ProClip forward so the angled edge goes into the gap. Press until you hear/feel
it snaps into place. Pull out the gap opener.
4. The ProClip is in place.
2(2)