BROSA Pluto Tripod Floor Lamp User manual

ASSEMBLY GUIDE
Pluto Tripod Floor Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Pole x 3 Socket part x 1
Shade screw x 1
Shade x 1
What you need
124
3
6
5

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 60W E27
220-240v ~ 50Hz

Step 1 Align rst (1) pole to the second pole (2) and rmly
screw them together. Continue with the third pole
pole (3). Repeat for all three legs. Align the formed
legs to the socket part (4) and rmly screw them
together.
1
1
1
222
4
3
33

Step 2 Place the shade (5) at the end of the socket part (4).
Carefully adjust the shade and tighten it in place with
the shade screw (6). Gently screw the correct bulb
(not included) into the bulb socket.
6
5
4

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.