BROSA Pictor Spring Table Lamp User manual

ASSEMBLY GUIDE
Pictor Spring Table Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Light Stand x 1
What you need

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 25W E14
220-240v ~ 50Hz

Step 1 Pull the springs and attach to the poles. Gently
screw the correct bulb (not included) into the bulb
socket.

Step 2 Gently turn the handles to change the light direction
and pole angles.

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.